Nissan Rogue (T33) 2021-Present Service Manual: U2276 Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U2276 83

CAN comm err (CCM)

[CAN comm err (CCM)]
Diagnosis condition Ignition switch ON
Signal (terminal) CAN communication signal
87 Threshold ECM is not receiving CAN communication signal other than OBD (emission related diagnosis).
Diagnosis delay time 30 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted)

  • Chassis control module

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC U2276 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Ignition switch ON and wait at least 3 seconds.

  2. Check 1st trip DTC.

Is DTC U2276 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC U2276 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    U2259 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2259 87 CAN comm err (steering control unit) [CAN comm err (ste...
    U2384 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2384 83 CAN comm err (eVTC) [CAN comm err (eVTC)] Diagnosis con...

    Other materials:

    Power outlets
    Basic information Instrument panel Luggage area (if so equipped) The Nissan Rogue is equipped with power outlets located in the lower part of the instrument panel and, on some models, in the luggage area. These outlets allow you to power small electronic accessories while on the road. CAUTIO ...

    Tire pressure
    Tire Pressure Monitoring System (TPMS) Your Nissan Rogue is equipped with the TPMS, which monitors tire pressure on all wheels except the spare. If the “Tire Pressure Low – Add Air” warning appears, one or more tires are significantly under-inflated. The TPMS activates only when driving a ...

    P2127 App Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2127 00 APP SEN 2/CIRC (Throttle/Pedal position sensor/switch E circuit low) Diagnosis condition Engine running at idle Signal (terminal) Accelerator ...