Nissan Rogue (T33) 2021-Present Service Manual: U214e Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U214E 87

CAN comm err (combination meter)

[CAN comm err (combination meter)]
Diagnosis condition Ignition switch ON
Signal (terminal) CAN communication signal
Threshold ECM is not receiving CAN communication signal other than OBD (emission related diagnosis).
Diagnosis delay time 30 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted)

  • Combination meter

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC U214E is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Ignition switch ON and wait at least 3 seconds.

  2. Check 1st trip DTC.

Is DTC U214E detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC U214E is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    U214a Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U214A 83 CAN comm err (AWD/4WD) [CAN comm err (AWD/4WD)] Diagnos...
    U214f Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U214F 57 CAN comm err (BCM) [CAN comm err (BCM)] Diagnosis condi...

    Other materials:

    Removal and Installation. Inside Key Antenna
    Japan Production Models Removal and Installation REMOVALRemove luggage rear plate. Refer to Removal and Installation. Remove inside key antenna fixing clips , and then remove inside key antenna . INSTALLATIONNote the following items, and then install in the reverse order of removal.CAUTION: N ...

    Fuel Efficient Driving Tips
    Follow these Fuel Efficient Driving Tips to help maximize fuel economy in your Nissan Rogue. 1. Use smooth accelerator and brake input. Avoid rapid acceleration and sudden stops. Apply the accelerator and brakes smoothly. Maintain a consistent speed and coast when possible. 2. Maintain steady ...

    Appuie-tête/repose-tête
    Informations de base AVERTISSEMENT Dans le Nissan Rogue, les appuie-tête/repose-tête complètent les autres systèmes de sécurité du véhicule. Ils peuvent constituer une protection supplémentaire contre les blessures lors de certaines collisions arrière. Les appuie-tête/repose-tête rég ...