Nissan Rogue (T33) 2021-Present Service Manual: U1ca1-08 Lin Communication 2
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1CA1-08 |
LIN communication 2 (Local interconnect network communication 2) |
Diagnosis condition | Ignition switch ON |
| Signal (Terminal) | LIN (A/C switch assembly) signal | ||
| Threshold | A/C amp. is not transmitting or receiving LIN communication with A/C switch assembly | ||
| Diagnosis delay time | 2 second or more | ||
POSSIBLE CAUSE
-
A/C switch assembly
-
A/C amp.
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Select "Self diagnosis result" mode of "HVAC".
-
Check DTC.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
CHECK DTC
CONSULT
-
Ignition switch ON.
-
Select "Self diagnosis result" mode of "HVAC".
-
Check following DTC.
DTC Items
(CONSULT screen terms)Reference B24B4-02 A/C CONTROL COMM DTC Description
Is DTC detected?
YES>>Perform DTC diagnosis procedure that is detecting.
NO>>Replace A/C amp. Refer to Removal and Installation.
Other materials:
Symptom Diagnosis. Low Tire Pressure Warning Lamp Does Not Turn Off
Description
The low tire pressure warning lamp does not turn OFF after several seconds is passed after engine starts.
Diagnosis Procedure
CHECK TIRE PRESSURE
Ignition switch ON.
CAUTION:
Never start the engine.
Check the tire pressure for all wheels and adjust to the specified value ...
Diagnosis System (av Control Unit)
Nissanconnect with 8" Color Display
On Board Diagnosis Function
The AV control unit on board diagnosis performs the functions listed in the table below:DESCRIPTION Mode Description
Self Diagnosis
Audio system diagnosis.
Diagnoses the connections across system components.
...
Power Supply and Ground Circuit
Ecm
Diagnosis Procedure
CHECK THE BATTERY CABLE
Turn ignition switch OFF.
Check the battery cable for tightening enough.
NOTE:
Check the continuity between the battery cable and the battery terminal.
Is the inspection result normal?
YES>>
GO TO 2
...
