Nissan Rogue (T33) 2021-Present Service Manual: Trunk

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / System Description :: Diagnosis System (bcm) / Trunk

CONSULT Function (BCM - TRUNK)

DATA MONITOR

NOTE:

The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor Item

[Unit] 		Condition

Back door/trunk lid switch

[On/Off] 		Indicates [On/Off] condition of door ajar switch.

Ignition switch

[On/Off]

NOTE:

This item is displayed, but cannot be monitored.

Unlock sensor

[On/Off] 		Indicates [On/Off] condition of front door lock assembly LH (door unlock sensor) status.

Request switch back door/trunk lid

[On/Off] 		Indicates [On/Off] condition of back door opener switch (request switch).

Back door/trunk opener switch

[On/Off] 		Indicates [On/Off] condition of back door opener switch.

Back door/trunk status

[Open/Close] 		Indicates [Open/Close] condition of back door.
    Signal Buffer
    CONSULT Function (BCM - SIGNAL BUFFER) DATA MONITORNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) appl...
    Wiper
    CONSULT Function (BCM - WIPER) DATA MONITORNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable t...

    Other materials:

    P2563 Wastegate Control Valve Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2563 00 TC BOOST CONTROL POSITN SEN A (Turbocharger boost control position sensor A circuit range/performance) Diagnosis condition — Signal (terminal) — ...

    Dtc/circuit Diagnosis. Electric Parking Brake Indicator Lamp
    Component Function Check CHECK ELECTRIC PARKING BRAKE WARNING LAMP FUNCTION Check that electric parking brake warning lamp in combination meter turns ON for approximately 1 second after ignition switch is ON. Is the inspection result normal? YES>> GO TO 2. NO>> Refer to Diagno ...

    Basic Inspection. System Initialization
    Description Initialization of system should be conducted after the following conditions: Refer to Work Procedure. When the moonroof motor assembly or sunshade motor assembly is replaced. When the moonroof or sunshade does not operate normally. (Incomplete initialization conditions) Wor ...