Nissan Rogue (T33) 2021-Present Service Manual: Wiper

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / System Description :: Diagnosis System (bcm) / Wiper

CONSULT Function (BCM - WIPER)

DATA MONITOR

NOTE:

The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor Item

[Unit] 		Description

Rear wiper auto stop switch

[On/Off] 		Displays the status of the rear wiper stop position signal received from rear wiper motor.

Battery voltage (wiper)

[On/Off] 		Indicates [On/Off] condition of battery power supply (rear wiper) status.
    Trunk
    CONSULT Function (BCM - TRUNK) DATA MONITORNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable t...
    Ecu Diagnosis Information. Bcm
    Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle...

    Other materials:

    Fonctionnement du système LDW
    Témoin LDW (affiché sur l’écran d’informations du véhicule) Écran d’informations du véhicule Commandes au volant (côté gauche) Le système LDW du Nissan Rogue active la fonction d’alerte sortie de voie lorsque la vitesse du véhicule atteint environ 60 km/h (37 mi ...

    Symptom Diagnosis. Sunshade Does Not Operate Properly
    Description Sunshade does not operate normally. Sunshade open/close does not operate. Sunshade open/close operation is slow. Judder occurs during open/close operation of sunshade. Diagnosis Procedure CHECK SUNSHADE Check sunshade for damage, deformation, of interference with oth ...

    Writing of Calibration Data
    Work Procedure DESCRIPTIONIf only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA With C ...