Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Sunshade Does Not Operate Properly
Description
Sunshade does not operate normally.
-
Sunshade open/close does not operate.
-
Sunshade open/close operation is slow.
-
Judder occurs during open/close operation of sunshade.
Diagnosis Procedure
CHECK SUNSHADE
Check sunshade for damage, deformation, of interference with other parts.
Refer to Removal and Installation.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning parts.
CHECK SUNSHADE MOTOR ASSEMBLY POWER SUPPLY AND GROUND CIRCUIT
Check sunshade motor assembly power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
CHECK LIN COMMUNICATION CIRCUIT
Check LIN communication circuit. Refer to Diagnosis Procedure.
YES>>
GO TO 4.
NO>>Repair or replace the malfunctioning parts.
CHECK SUNSHADE SWITCH
Check sunshade switch.
Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Repair or replace the malfunctioning parts.
CHECK COMMUNICATION CIRCUIT
Check communication circuit.
Refer to Component Function Check.
Is the inspection result normal?
YES>>Replace sunshade motor assembly. Refer to Removal and Installation.
NO>>Repair or replace the malfunctioning parts.
Other materials:
System Description. System
Lithium Ion Battery 12v
System Description
SYSTEM DIAGRAM
Component Function
12V sub battery (lithium ion battery)
Refer to 12V Sub Battery (Lithium Ion Battery).
Combination Meter
Receives li-ion battery error signal from 12V sub battery (lithium ion battery) through IPDM E/R via ...
Removal and Installation. Mood Lamp (center Console)
Exploded View
Mood lamp (center console) assembly (Bulb type)
Center console assembly
Mood lamp (center console tray) assembly (LED type)
: Pawl
: Nissan Ariya Vehicle front
Removal & Installation
REMOVALCAUTION:
Disconnect the battery negative terminal or rem ...
Laser Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
Distance sensor
Harness connector B2 ...
