Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Normal Operating Condition

Nissan Rogue (T33) 2021-Present Service Manual / Driver Controls :: Wiper & Washer / Symptom Diagnosis :: Normal Operating Condition

Description

FRONT WIPER MOTOR PROTECTION FUNCTION

  • IPDM E/R may stop the front wiper to protect the front wiper motor if any obstruction (operation resistance) such as a large amount of snow is detected during the front wiper operation.

  • At that time turn OFF the front wiper and remove the foreign object. Then reactivate the front wiper. The wiper will operate normally.

REAR WIPER MOTOR PROTECTION FUNCTION

  • BCM may stop rear wiper to protect the rear wiper motor when the rear wiper is stopped for 5 seconds or more due to a snowfall.

  • Rear wiper operates normally 1 minute after the obstacles are removed with rear wiper OFF.

    Symptom Diagnosis. Front Wiper Does Not Operate
    Description The front wiper does not operate under any operation conditions. Diagnosis Procedure CHECK FRONT WIPER REQUEST SIGNAL INPUT CONSULT Select “ALL SIGNALS” in "Data...
    Removal and Installation. Front Wiper
    Exploded View Removal 1. Front wiper arm cap 2. Front wiper blade RH 3. Front wiper arm RH 4. Tube connector 5. Front wiper drive assembly 6. Front wiper arm LH 7. Front wiper b...

    Other materials:

    Motion-activated liftgate
    Basic information The Nissan Rogue liftgate can be opened using a quick forward kicking motion beneath the center area of the rear bumper. The kick motion sensor a is located behind the bumper. When your foot moves under and away from the detection area b while carrying the Intelligent Key, ...

    B20dd-73 Ign Relay on Circ
    DTC Description IPDM E/R operates the ignition relay when it receives an ignition ON signal from BCM via CAN communication. Turn the ignition relay OFF by pressing the push-button ignition switch once when the Nissan Ariya vehicle speed is 2.5 MPH (4 km/h) or less. Turn the igniti ...

    Evap Control System Pressure Sensor
    Component Inspection CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR Turn ignition switch OFF. Remove EVAP control system pressure sensor with its harness connector connected from EVAP canister. Always replace O-ring with a new one. Install a vacuum pump to EVAP control system pressure se ...