Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Front Wiper Does Not Operate
Description
The front wiper does not operate under any operation conditions.
Diagnosis Procedure
CHECK FRONT WIPER REQUEST SIGNAL INPUT
CONSULT
-
Select “ALL SIGNALS� in "Data monitor" mode of “IPDM E/R�.
-
Switch the front wiper switch to HI and LO.
-
With operating the front wiper switch, check the status of the "Front wiper relay" and "Front wiper HI/LO relay".
Monitor item Condition Monitor status Front wiper relay Front wiper switch INT On (during sweep) LO On HI On OFF Off Front wiper HI/LO relay Front wiper switch INT Off LO Off HI On OFF Off
Is the inspection result normal?
YES>>GO TO 2.
NO>>GO TO 6.
CHECK WIPER RELAY OPERATION
-
Ignition switch ON.
-
Switch the front wiper switch to HI and LO, check front wiper operation.
Is front wiper operation normally?
YES>>Inspection End.
NO - 1>>HI and LO does not operate :GO TO 3.
NO – 2>>HI only does not operate :Refer to Diagnosis Procedure.
NO – 3>>LO only does not operate :Refer to Diagnosis Procedure.
CHECK FRONT WIPER MOTOR FUSE
-
Ignition switch OFF.
-
Check that the following fuse is not blown (open):
Location No. Capacity IPDM E/R 77 30 A
Is the fuse blown (open)?
YES>>Replace the blown (open) fuse after repairing the cause of blown (open).
NO>>GO TO 4.
CHECK FRONT WIPER MOTOR GROUND CIRCUIT
Check front wiper motor ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Replace front wiper motor. Refer to Removal and Installation.
NO>>Replace IPDM E/R. Refer to Removal and Installation.
CHECK COMBINATION SWITCH
Perform the inspection of the combination switch. Refer to Symptom Table.
Is combination switch normal?
YES>>Replace BCM. Refer to Removal and Installation.
NO>>Replace combination switch. Refer to Removal and Installation.
Other materials:
Dtc/circuit Diagnosis. B2ccf-04 Passenger Door Mirror Control Module
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B2CCF-04
Passenger door mirror control module
(Passenger door mirror control module)
Diagnosis condition
Ignition switch is ON or OFF (auto ACC status).
Signal ...
Meter Speaker Signal Circuit
Diagnosis Procedure
CHECK METER SPEAKER CIRCUIT FOR OPEN
Ignition switch OFF.
Disconnect combination meter harness connector and meter speaker harness connector.
Check the continuity between combination meter harness connector and meter speaker harness connector.
Combination meter ...
P052e Crankcase Ventilation Valve
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P052E
00
PCV Regulator Valve Performance
(PCV Regulator Valve Performance)
Diagnosis condition
After engine warmed up
Engine running at idle
Int ...
