Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Normal Operating Condition
Description
The following symptoms are normal operations, and they do not indicate a malfunction.
| Symptom | Cause | Action to take | Reference |
|---|---|---|---|
| Entry/exit assist function do not operate. | Entry/exit assist function is disabled. | Change the settings. | Description |
| Entry assist function does not operate. | Manual operation with power seat switch LH was performed after exit assist function execution. | Perform the memory function. | Description |
| Lumbar support do not perform memory operation. | The lumbar support system is controlled independently with no link to the automatic drive positioner system. | — | System Description |
| Memory function, entry/exit assist function, log-in function (with navigation system) or Intelligent Key interlock function does not operate. | The operating conditions are not fulfilled. | Fulfill the operation conditions. | Memory function: System Description |
| Exit assist function: System Description | |||
| Entry assist function: System Description | |||
| Log-in function: System Description | |||
| Intelligent Key interlock function: System Description (with navigation system) or System Description (without navigation system) |
Other materials:
Distance Sensor Alignment
Work Procedure
Always perform the radar alignment after removing and installing or replacing the distance sensor.Application Notice Type Description
TYPE 1
When using KV99112700 for radar alignment. Refer to Description.
TYPE 2
When using 1-20-2851-1 for radar alignment. Refer to Des ...
Trip computer
Basic information
The trip computer switches are located on the left side of the steering wheel, allowing easy access while driving the Nissan Rogue.
Scroll dial – used to move through menu items and select functions within the vehicle information display; it supports up/down navigation and pu ...
Main Line Between Hvac and a-Bag Circuit
Diagnosis Procedure
CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect the following harness connectors.
A/C amp.
Harness connectors M31 and E152
Check the continuity between the ...
