Nissan Rogue (T33) 2021-Present Service Manual: Main Line Between Hvac and a-Bag Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Main Line Between Hvac and a-Bag Circuit

Diagnosis Procedure

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Disconnect the following harness connectors.

    • A/C amp.

    • Harness connectors M31 and E152

  4. Check the continuity between the A/C amp. harness connector and the harness connector.

    A/C amp. harness connector Harness connector Continuity
    Connector No. Terminal No. Connector No. Terminal No.
    M55 50 M31 50J Existed
    70 49J Existed

Is the inspection result normal?

YES (Present error)>>

Check CAN system type decision again.

YES (Past error)>>

Error was detected in the main line between the A/C amp. and the air bag diagnosis sensor unit.

NO>>

Repair the main line between the A/C amp. and the air bag diagnosis sensor unit harness connector.

    Malfunction Area Chart
    Vehicle CAN Communication Circuit MAIN LINE Malfunction area Reference Main line between A/C amp. and air bag diagnosis sensor unit circuit Diagnosis Procedure Main line between...
    Main Line Between Anc and Pwbd Circuit
    Diagnosis Procedure CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harne...

    Other materials:

    P0335 Ckp Sensor 1
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0335 00 CKP SEN/CIRCUIT (Crankshaft position sensor “A” circuit) Diagnosis condition Engine running or cranking Signal (terminal) Crankshaft posit ...

    Additional Service When Replacing Side Radar
    Work Procedure Always perform the side radar configuration after replacing the side radar.SIDE RADAR CONFIGURATION Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual. >> GO TO 2. SIDE RADAR ALIGNMENT Perform the side radar alignment with ...

    P0030 A/f Sensor 1 Heater
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0030 00 HO2S1 HTR (B1) (HO2S heater control circuit bank 1 sensor 1) Diagnosis condition Engine running at idle Signal (terminal) A/F sensor 1 heater ...