Nissan Rogue (T33) 2021-Present Service Manual: Main Line Between Anc and Pwbd Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Main Line Between Anc and Pwbd Circuit

Diagnosis Procedure

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Disconnect the following harness connectors.

    • BCM

    • Active noise control unit

    • Automatic back door control unit

  4. Check the continuity between the active noise control unit harness connector and the automatic back door control unit harness connector.

    Active noise control unit harness connector Automatic back door control unit harness connector Continuity
    Connector No. Terminal No. Connector No. Terminal No.
    B92 7 B55 32 Existed
    19 16 Existed

Is the inspection result normal?

YES (Present error)>>

Check CAN system type decision again.

YES (Past error)>>

Error was detected in the main line between the active noise control unit and the automatic back door control unit.

NO>>

Repair the main line between the active noise control unit and the automatic back door control unit.

    Main Line Between Hvac and a-Bag Circuit
    Diagnosis Procedure CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harne...
    Main Line Between Pwbd and M&a Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...

    Other materials:

    P00fe Evap Control System
    DTC Description This diagnosis detects clogs in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve.ECM controls EVAP control system as below. ECM monitors EVAP line pressure change to diagnose if there is no clogging between EVAP canister and fuel tank. E ...

    Diagnosis System [abs Actuator and Electric Unit (control Unit)]
    CONSULT Function APPLICATION ITEMSCONSULT can display each diagnostic item using the diagnostic test modes as follows. Diagnosis mode CGW Status Description Restricted Mode Diag Test Mode Open Mode Self Diagnosis Result Display Display Display Display non-network DTC which ABS ...

    Removal and Installation. Terminal Plate
    Exploded View 1. Terminal plate cover 2. Terminal plate 3. Terminal plate bracket A. Harness (rear) B. Harness (center) C. Harness (front) : Pawl         Removal and Installation REMOVALDisconnect the 12V battery negative a ...