Nissan Rogue (T33) 2021-Present Service Manual: Stop Lamp Switch

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Stop Lamp Switch

Component Inspection

CHECK STOP LAMP SWITCH-1

  1. Turn ignition switch OFF.

  2. Disconnect stop lamp switch harness connector.

  3. Check the continuity between stop lamp switch terminals as per the following conditions.

    Stop lamp switch Condition Continuity
    + −
    Terminals
    4 3 Brake pedal Fully released Existed
    Slightly depressed Not existed
    1 2 Brake pedal Fully released Not existed
    Slightly depressed Existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 2.

CHECK STOP LAMP SWITCH-2

  1. Adjust stop lamp switch installation. Refer to Inspection and Adjustment.

  2. Check the continuity between stop lamp switch terminals as per the following conditions.

    Stop lamp switch Condition Continuity
    + −
    Terminals
    4 3 Brake pedal Fully released Existed
    Slightly depressed Not existed
    1 2 Brake pedal Fully released Not existed
    Slightly depressed Existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace stop lamp switch. Refer to Exploded View (Without ProPILOT Assist 2.1) or Exploded View (With ProPILOT Assist 2.1).

    Spark Plug
    Component Inspection WARNING: Unlike normal tester resistance meters, an insulation resistance tester (multi-tester) is for measuring an insulation resistance with 500 V applied...
    Throttle Control Motor
    Component Inspection CHECK THROTTLE CONTROL MOTOR Turn ignition switch OFF. Disconnect electric throttle control actuator harness connector. Check the resistance between electri...

    Other materials:

    Dtc/circuit Diagnosis. B2920-55 Driver Seat Control Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2920-55 Driver seat control unit (Driver seat control unit) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Configuration ...

    P0401 Egr System
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0401 00 EGR A FLOW INSUFFICIENT (EGR A flow insufficient detected) Diagnosis condition — Signal (terminal) — Threshold ECM detects that th ...

    P0446 Evap Canister Vent Control Valve
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0446 00 VENT CONTROL VALVE (EVAP System Vent Control Circuit) Diagnosis condition Engine running at idle Signal (terminal) EVAP canister vent control ...