Nissan Rogue (T33) 2021-Present Service Manual: Rear Final Drive: R145 :: Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts.
| Possible cause and SUSPECTED PARTS | Symptom | Reference | |
|---|---|---|---|
| Noise | Vibration | ||
| Gear tooth rough | × | – | Inspection |
| Gear contact improper | × | – | Adjustment |
| Tooth surfaces worn | × | – | Inspection |
| Backlash incorrect | × | – | Adjustment |
| Companion flange excessive runout | × | – | Adjustment |
| Gear oil improper | × | – | Inspection |
| PROPELLER SHAFT | × | – | NVH of REAR PROPELLER SHAFT in this section. |
| AXLE AND SUSPENSION | × | – | NVH in FAX, RAX, FSU and RSU sections. |
| TIRE | × | – | NVH in WT section. |
| ROAD WHEEL | × | – | NVH in WT section. |
| DRIVE SHAFT | × | – | NVH in FAX and RAX section. |
| BRAKE | × | – | NVH in BR section. |
| STEERING | × | – | NVH in ST section. |
| ELECTRO-HYDRAULIC COUPLING | × | × | Removal and Installation |
×: Applicable
Other materials:
With Idle Start/stop. Symptom Diagnosis. Charging System
Charging System
Symptom Table
Symptom Reference
Discharged 12V battery
Refer to Work Flow (With EXP-800 NI or GR8-1200 NI) or Work Flow (Without EXP-800 NI or GR8-1200 NI).
The charge warning lamp does not illuminate when the ignition switch is set to ON.
The charge warning lamp ...
P00d2 Ho2s2 Heater
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P00D2
00
Heated O2 sensor heater B1 sensor 2
(HO2S heater control circuit range/performance bank 1 sensor 2)
Diagnosis condition
—
Signal (terminal)
...
Lane Camera (front Camera Unit)
C2500-49 Front Camera Unit
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C2500-49
Camera unit malf
(Camera unit malfunction)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
-
T ...
