Nissan Rogue (T33) 2021-Present Service Manual: Power Supply and Ground Circuit

Diagnosis Procedure

CHECK FUSES

Check that the following fuses are not blown:

Unit Power source Fuse No. Capacity
AWD control unit Battery 22 15 A
Ignition switch ON or START 9 10 A

Is the fuse blown?

YES>>

Replace the blown fuse after repairing the affected circuit.

NO>>

GO TO 2.

CHECK POWER SUPPLY CIRCUIT

  1. Disconnect AWD control unit harness connector.

  2. Check voltage between AWD control unit harness connector and ground.

    (+) (−) Ignition switch position
    AWD control unit
    Connector Terminal OFF ON START
    C75 6 Ground Battery voltage Battery voltage Battery voltage
    5 Ground 0 V Battery voltage Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connector.

CHECK GROUND CIRCUIT

  1. Ignition switch OFF.

  2. Check continuity between AWD control unit harness connector and ground.

    AWD control unit — Continuity
    Connector Terminal
    C75 1 Ground Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace harness or connector.

    U3d02-06 Incomplete Programming
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition U3D02-06 INCOMP PROGRAMMING (Incomplete programming) Diagnosis c...
    Awd Warning Icon/display
    Diagnosis Procedure CHECK POWER SUPPLY AND GROUND CIRCUIT Perform the trouble diagnosis for power supply and ground circuit. Refer to Diagnosis Procedure. Is the inspection resu...

    Other materials:

    Tcm
    Reference Value CONSULT DATA MONITOR STANDARD VALUE In CONSULT, electric shift timing or lock-up timing, i.e. operation timing of each solenoid valve, is displayed. Therefore, if there is an obvious difference between the shift timing estimated from a shift shock (or engine speed variation ...

    Ecu Diagnosis Information. Electrically-Driven Intelligent Brake Unit
    DTC Index DTC Display item Brake warning lamp Brake system warning lamp Refer to B14E0-02 Wheel sensor OFF ON DTC Description B14E0-09 Wheel sensor OFF ON DTC Description B14E0-11 Wheel sensor OFF ON DTC Description B14E0-12 Wheel sensor ...

    B2720-34 Corner Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2720-34 CORNER SENSOR [RL] (Corner sensor [rear left]) Diagnosis condition When ignition switch is ON Signal (terminal) Rear sonar sensor signal LH outer Th ...