Nissan Rogue (T33) 2021-Present Service Manual: Power Distribution System :: Symptom Diagnosis. Push-Button Ignition Switch Does Not Operate

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Power Control System / Power Distribution System :: Symptom Diagnosis. Push-Button Ignition Switch Does Not Operate

Push-Button Ignition Switch Does Not Operate

Diagnosis Procedure

Description

Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.

NOTE:

The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent Key system are closely related to each other regarding control. The Nissan Ariya vehicle security function can operate only when the door lock and power distribution system are operating normally.

Conditions of Vehicle (Operating Conditions)

  • One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.

CHECK INTELLIGENT KEY SYSTEM (DOOR LOCK FUNCTION)

Operate door request switch and check that door lock/unlock operates.

Is the inspection result normal?

YES>>

GO TO 2

NO>>

Refer to Diagnosis Procedure.

PERFORM WORK SUPPORTS

CONSULT

Select “Inside/outside antenna diagnosis” in "Work supports" mode of "INTELLIGENT KEY".

NO>>

GO TO 3

CHECK SELF DIAGNOSIS RESULT

CONSULT

Select “Self diagnosis result” mode of “INTELLIGENT KEY”.

Is DTC detected?

YES>>

Refer to DTC Index.

NO>>

GO TO 4.

CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT

Check push-button ignition switch circuit. Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Repair or replace malfunctioning parts.

REPLACE INTELLIGENT KEY UNIT

  1. Replace Intelligent Key unit. Refer to Removal and Installation.

  2. Confirm the operation again.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

    Push-Button Ignition Switch Circuit
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Push switch” in “Data monitor” mode of “INTELLIGENT KEY”. Check the push-button ignition ...
    Power Distribution System. Removal and Installation. Push-Button Ignition Switch
    Push-Button Ignition Switch Removal and Installation REMOVALRemove switch panel. Refer to Removal and Installation. Disengage the fixing pawls using a remover tool (A) and then ...

    Other materials:

    C0069 G Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0069 00 Yaw Rate/Longitude Sensors (Yaw Rate/Longitude Sensors) Diagnosis condition Ignition switch ON Battery voltage: 11 V Signal CAN ...

    P34ac Electric Intake Valve Timing Control Actuator
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P34AC 00 A camshaft posi actuator posi sens B1 (A Camshaft Position Actuator Position Sensor A Circuit Bank 1) Diagnosis condition — Signal (terminal) ...

    Removal and Installation. Side Guard Molding
    Exploded View Front door panel Front side guard molding Rear side guard molding Rear door panel Double-sided tape [t: 1.2 mm (0.047 in)]     : Clip : Nissan Ariya Vehicle front : Always replace after every disassembly. Front Side Guar ...