Nissan Rogue (T33) 2021-Present Service Manual: P2483 Exhaust Gas Temperature Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P2483 Exhaust Gas Temperature Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P2483 00

Exhaust gas temp sensor bank 1

(Exhaust Gas Temperature Sensor Circuit Range/Performance Bank 1 Sensor 5) 		Diagnosis condition Ignition switch ON
Signal —
Threshold The comparison result of signals transmitted to ECM from each temperature sensor (EGT sensor, sensor, ECT sensor, FTT sensor, and IAT sensor) shows that the temperature of the exhaust gas temperature sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state.
Diagnosis delay time —

POSSIBLE CAUSE

  • Exhaust gas temperature sensor

  • Harness or connectors

    (High or low resistance in the exhaust gas temperature sensor circuit.)

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

  • Before performing the following procedure, do not add fuel.

  • Before performing the following procedure, check that fuel level is between 1/4 and 4/4.

  • Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Move the Nissan Ariya vehicle to a cool place.

    NOTE:

    Cool the vehicle in an environment of ambient air temperature between −10°C (14°F) and 35°C (95°F).

  2. Turn ignition switch OFF and leave the Nissan Ariya vehicle for 12 hours.

    CAUTION:

    Never turn ignition switch ON during this procedure.

    NOTE:

    The Nissan Ariya vehicle must be cooled with the hood open.

  3. Start engine and let it idle for 5 minutes or more.

    CAUTION:

    Never turn ignition switch OFF during idling.

  4. Check the DTC.

Is the DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK EXHAUST GAS TEMPERATURE SENSOR POWER SUPPLY

  1. Turn ignition switch OFF.

  2. Disconnect exhaust gas temperature sensor harness connector.

  3. Turn ignition switch ON.

  4. Check the voltage between exhaust gas temperature sensor harness connector and ground.

    + −

    Voltage

    (Approx.)
    Exhaust gas temperature sensor
    Connector Terminal
    E26 1 Ground 5 V

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

GO TO 3.

CHECK EXHAUST GAS TEMPERATURE SENSOR GROUND CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connector.

  3. Check the continuity between exhaust gas temperature sensor harness connector and ECM harness connector.

    Exhaust gas temperature sensor ECM Continuity
    Connector Terminal Connector Terminal
    E26 2 F71 99 Existed

  4. Also check harness for short to power.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK EXHAUST GAS TEMPERATURE SENSOR INPUT SIGNAL CIRCUIT

  1. Check the continuity between exhaust gas temperature sensor harness connector and ECM harness connector.

    Exhaust gas temperature sensor ECM Continuity
    Connector Terminal Connector Terminal
    E26 1 F71 113 Existed

  2. Also check harness for short to ground and to power.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace error-detected parts.

CHECK EXHAUST GAS TEMPERATURE SENSOR

Check the exhaust gas temperature sensor. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Replace exhaust gas temperature sensor. Refer to ComponentPartsLocation.

    P2482 Exhaust Gas Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2482 00 Exhaust gas temp sensor bank 1 (Exhaust Gas Temperature...
    P2484 Exhaust Gas Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2484 00 Exhaust gas temp sensor bank 1 (Exhaust Gas Temperature...

    Other materials:

    Basic Inspection. Front Disc Brake. Disc Rotor
    Disc Rotor Inspection INSPECTIONUneven wearCheck the uneven wear of the disc rotor using a micrometer. Replace the disc rotor if the thickness is below the wear limit. For 2WD: Refer to Removal and Installation. For AWD: Refer to Removal and Installation. Thickness variation (measured ...

    Kr15ddt. Periodic Maintenance
    Air Cleaner Filter Exploded View 1. Air duct (Inlet) 2. Clip 3. Mounting rubber 4. Mounting rubber 5. Bracket 6. Clip 7. Air cleaner body 8. Mounting rubber 9. Collar 10. Air cleaner filter 11. Air cleaner cover 12. Mass a ...

    System Description. System
    System Description SYSTEM DIAGRAMINPUT/OUTPUT SIGNAL CHART Switch Input signal to BCM BCM function Actuator Rear window defogger switch Defogger switch signal Rear window defogger control Rear window defogger OPERATION DESCRIPTION Turn rear window defogger switch ON when the e ...