Nissan Rogue (T33) 2021-Present Service Manual: P1c92-82 Communication Error

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Charging System / With Idle Start/stop :: Dtc/circuit Diagnosis / P1c92-82 Communication Error

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P1C92-82

Communication error

(Communication error) 		Diagnosis condition Engine running at idle
Signal (terminal) CAN communication signal
Threshold Sub starter & generator cannot communicate CAN communication signal
Diagnosis delay time 2 second or less

POSSIBLE CAUSE

  • Sub starter & generator

  • ECM

  • Harness or connector (CAN communication line between sub starter & generator and ECM)

FAIL-SAFE

Inhibit the idle start/stop system

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine and let it idle and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “Sub starter & generator”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace the malfunctioning parts.

REPLACE ECM

  • Replace ECM. Refer to ECM : Removal & Installation.

  • Perform “DTC Confirmation Procedure”. Refer to DTC Description.

Is DTC“P1C92-82” displayed again?

YES>>

Replace sub starter & generator. Refer to Removal and Installation.

NO>>

Inspection End.

    P1c91-A2 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1C91-A2 Sub starter & generator (Sub starter & gene...
    P1c95-13 Ignition Power Supply Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1C95-13 Ignition power supply circuit (Ignition power suppl...

    Other materials:

    OFF-ROAD mode (for Rock Creek)
    When the shift lever is not in the R (Reverse) position, selecting the OFF-ROAD mode with the Drive Mode Selector changes how the Intelligent Around View Monitor operates on your Nissan Rogue. 1. When the OFF-ROAD mode is selected, the Intelligent Around View Monitor automatically turns on and the f ...

    System
    System Description Without ProPILOT Assist 2.1SYSTEM DIAGRAM Component Description ECM ECM BCM System Description ABS actuator and electric unit (control unit) ABS Actuator and Electric Unit (Control Unit) Chassis control module Chassis Control Module TCM Comp ...

    Information Display (combination Meter)
    Remote Engine Start Information DESIGN/PURPOSEInformation display informs the driver that the engine can be started. Symbol Message Push brake and start switch to drive SYNCHRONIZATION WITH MASTER WARNING LAMPNo applicableSYSTEM DIAGRAMSIGNAL PATH BCM transmits meter display signal ...