Nissan Rogue (T33) 2021-Present Service Manual: P1c91-A2 Sub Starter & Generator
DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| P1C91-A2 |
Sub starter & generator (Sub starter & generator) |
Diagnosis condition |
|
| Signal (terminal) | Battery voltage | ||
| Threshold | 12 V battery voltage decreases to 8 V or less | ||
| Diagnosis delay time | 1 second or less | ||
POSSIBLE CAUSE
-
Harness or connectors (12V battery voltage circuits are open or short circuit)
-
12V battery
FAIL-SAFE
Inhibit the idle start/stop system
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Start the engine and let it idle and wait for 1 second or more.
-
Wait for 1 second or more.
-
Select “Self diagnosis result” mode of “Sub starter & generator”.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
CHECK 12V BATTERY
Check 12V battery. Refer to Work Flow.
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace 12V battery. Refer to Removal and Installation.
Other materials:
Utilisation et précautions hivernales
AVERTISSEMENT DE SÉCURITÉ
Par temps de gel, le liquide lave-glace peut se transformer instantanément en glace sur le pare-brise froid de votre Nissan Rogue, obstruant totalement votre vue. Utilisez toujours la fonction de dégivrage du pare-brise pour réchauffer le verre avant d'actionner le la ...
P014c A/f Sensor 1
DTC Description
DTC DETECTION LOGICTo judge malfunctions, this
diagnosis measures response time of the A/F signal computed by ECM from
the A/F sensor 1 signal. The time is compensated by engine operating
(speed and load), fuel feedback control constant, and the A/F sensor 1
temperature inde ...
C1220-54 Incomplete Air Bleeding
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detecting condition
C1220-54
INCOMP AIR BLEEDING
(Incomplete air bleeding)
Diagnosis condition
Ignition switch: ON
Signal
—
Threshold
Air bleeding of electro-hydraulic co ...
