Nissan Rogue (T33) 2021-Present Service Manual: P1c90-49 Sub Starter & Generator

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Charging System / With Idle Start/stop :: Dtc/circuit Diagnosis / P1c90-49 Sub Starter & Generator

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P1C90-49

Sub starter & generator

(Sub starter & generator) 		Diagnosis condition Engine running at idle
Signal (terminal) -
Threshold Sub starter & generator internal malfunction
Diagnosis delay time 10 seconds or more

POSSIBLE CAUSE

Sub starter & generator

FAIL-SAFE

Inhibit the idle start/stop system

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine and let it idle and wait for 10 seconds or more.

  2. Select “Self diagnosis result” mode of “Sub starter & generator”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

REPLACE SUB STARTER & GENERATOR

Replace sub starter & generator. Refer to Removal and Installation.

>>

Inspection End.

    With Idle Start/stop. Dtc/circuit Diagnosis
    P1c90-55 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1C90-55 Sub starter & generator (Sub starter & gene...

    Other materials:

    Symptom Diagnosis. Sunshade Does Not Operate Properly
    Description Sunshade does not operate normally. Sunshade open/close does not operate. Sunshade open/close operation is slow. Judder occurs during open/close operation of sunshade. Diagnosis Procedure CHECK SUNSHADE Check sunshade for damage, deformation, of interference with oth ...

    Rear Final Drive: R145. Removal and Installation
    Side Oil Seal Exploded View Rear final drive assembly Side oil seal     Outer circumference         : Always replace after every disassembly. : Apply gear oil. Removal and Installation REMOVALDrain gear oil. Refer to Draining. Remo ...

    Rear View Monitor. Basic Inspection. Diagnosis and Repair Work Flow
    Diagnosis and Repair Work Flow Work Flow OVERALL SEQUENCE Reference 1··· CONSULT Function Reference 2··· DTC Index Reference 3··· Symptom Table DETAILED FLOWINTERVIEW AND SYMPTOM CONFIRMATION Check the malfunction symptoms by performing the following items. Interview ...