Nissan Rogue (T33) 2021-Present Service Manual: P1c90-55 Sub Starter & Generator

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Charging System / With Idle Start/stop :: Dtc/circuit Diagnosis / P1c90-55 Sub Starter & Generator

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P1C90-55

Sub starter & generator

(Sub starter & generator) 		Diagnosis condition Engine running at idle
Signal (terminal) -
Threshold Configuration is not performed
Diagnosis delay time -

POSSIBLE CAUSE

  • Configuration is not performed

  • Sub starter & generator

FAIL-SAFE

-

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine and let it idle.

  2. Select “Self diagnosis result” mode of “Sub starter & generator”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

PERFORM CONFIGURATION (SUB STARTER & GENERATOR)

  1. Perform configuration (Sub starter & generator). Refer to Description.

  2. Perform DTC confirmation procedure. Refer to DTC Description.

Is DTC detected?

Yes>>

Replace sub starter & generator. Refer to Removal and Installation.

NO>>

Inspection End.

    P1c90-49 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1C90-49 Sub starter & generator (Sub starter & gene...
    P1c91-14 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1C91-14 Sub starter & generator (Sub starter & gene...

    Other materials:

    Basic Inspection. Configuration (air Bag Diagnosis Sensor Unit)
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the air bag diagnosis sensor unit.The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSUL ...

    Vehicle information display warnings and indicators
    Engine start operation indicator This indicator appears when the shift position is set to P (Park). It informs the driver that the engine will start when the ignition switch is pushed while depressing the brake pedal. The Nissan Rogue engine can be started directly in any ignition switch position. ...

    Removal and Installation. Brake Power Backup Unit
    Exploded View 1 Brake power backup unit 2 Bracket (lower) 3 Bracket (upper) Removal & Installation REMOVALPower switch OFF and disconnect CONSULT from DDL2 diagnosis connector. Check that room lamps are turned OFF after closing all doors including back door, and then ...