Nissan Rogue (T33) 2021-Present Service Manual: P1097 Humidity Temperature Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P1097 Humidity Temperature Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P1097 00

Humidity temperature sensor

(Humidity temperature sensor Circuit Low) 		Diagnosis condition IGN ON
Signal (terminal) Humidity temperature sensor　signal
Threshold An excessively low temperature output from the humidity temperature sensor is sent to ECM.
Diagnosis delay time 2 seconds.

POSSIBLE CAUSE

  • Humidity temperature sensor (Mass air flow sensor)

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

DTC Confirmation Procedure

If DTC Confirmation Procedure has previously conducted,alwaiys peiform the following procedure before conducting the next tesut.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

Is DTC is detected?

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and wait at least 30 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REPLACE MASS AIR FLOW SENSOR

Replace Mass air flow sensor. Refer to Exploded View.

>>

INSPECTION END

    P1096 Humidity Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1096 00 Humidity temperature sensor (Humidity temperature senso...
    P1098 Humidity Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1098 00 Humidity temperature sensor (Humidity temperature senso...

    Other materials:

    Air Fuel Ratio Initial Learning
    Description Air fuel ratio initial learning of ECM to learn the air fuel ratio that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: When ECM is replaced* When engine assembly is replaced* When electric throttle con ...

    Removal and Installation. Front Washer Nozzle and Tube
    Exploded View Front washer nozzle LH (integrated with front wiper arm LH) Front washer nozzle RH (integrated with front wiper arm RH) Tube connector Front washer tube B Joint Front washer tube A Washer tank         : Clip Hyd ...

    Back Door Open Function
    System Description SYSTEM DIAGRAM*1: With automatic back door system models*2: Without automatic back door system modelsBACK DOOR OPEN FUNCTION (WITHOUT AUTOMATIC BACK DOOR SYSTEM MODELS) When the BCM detects that back door opener switch is pressed, then Intelligent Key unit transmits the requ ...