Nissan Rogue (T33) 2021-Present Service Manual: P1096 Humidity Temperature Sensor
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P1096 | 00 |
Humidity temperature sensor (Humidity temperature sensor Circuit High) |
Diagnosis condition | IGN ON |
| Signal (terminal) | Humidity temperature sensor signal | |||
| Threshold | An excessively high temperature output from the humidity temperature sensor is sent to ECM. | |||
| Diagnosis delay time | 2 seconds. | |||
POSSIBLE CAUSE
-
Humidity temperature sensor (Mass air flow sensor)
FAIL-SAFE
Not applicable
DTC Confirmation Procedure
DTC Confirmation Procedure
If DTC Confirmation Procedure has previously conducted,alwaiys peiform the following procedure before conducting the next tesut.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
Is DTC is detected?
>>GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Start engine and wait at least 30 seconds.
-
Check DTC.
Is DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
REPLACE MASS AIR FLOW SENSOR
Replace Mass air flow sensor. Refer to Exploded View.
>>
INSPECTION END
Other materials:
C1203-86 Abs Signal
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detecting condition
C1203-86
ABS SYSTEM
(Antilock brake system)
Diagnosis condition
Ignition switch: ON
Nissan Ariya Vehicle running
Signal
Wheel speed signals
...
Kr15ddt. Service Data and Specifications (sds). Service Data and Specifications (sds)
Service Data and Specifications (sds)
Periodical Maintenance Specification
ENGINE COOLANT CAPACITY (APPROXIMATE)Unit: (US qt, Imp qt) Engine coolant capacity (With reservoir tank at “MAX” level)
8.5 (9, 7-1/2)
Reservoir tank engine coolant capacity (At “MAX” level)
0. ...
Steering Switch Signal B Circuit
Component Function Check
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Ignition switch ON.
Select “Steering switch input” in “Data monitor” mode of “M&A”.
Check that the function operates normally according to the following conditions:
Condition Value
CONTRO ...
