Nissan Rogue (T33) 2021-Present Service Manual: P0a1e Sub Starter & Generator

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P0a1e Sub Starter & Generator

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P0A1E 00

Starter/generator control module

(Starter/generator control module) 		Diagnosis condition Engine running at idle
Signal (terminal) CAN communication signal
Threshold Less than 5.5 V, or more than 17.5 V
Diagnosis delay time 10 seconds or more

POSSIBLE CAUSE

Sub starter & generator

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine and let it idle and wait for 10 seconds or more.

  2. Perform “Self Diagnostic Result” mode of “ECM”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection end.

Diagnosis Procedure

CHECK CAN COMMUNICATION CIRCUIT

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

Is inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace error-detected parts.

CHECK DTC WITH SUB STARTER & GENERATOR

Check DTC with sub starter & generator. Refer to CONSULT Function (SUB STARTER & GENERATOR).

Is DTC C1C90-49 detected?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK SUB STARTER & GENERATOR

Check sub starter & generator. Refer to Diagnosis Procedure.

Is inspection result normal?

YES>>

INSPECTION END

NO>>

Repair or replace error-detected parts.

    P0850 Pnp Switch
    DTC Description DESCRIPTIONTransmission range switch is turn ON when the selector lever is P or N.ECM detects the position because the continuity of the line (the ON) exists.DTC...
    P1096 Humidity Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1096 00 Humidity temperature sensor (Humidity temperature senso...

    Other materials:

    Motion-activated liftgate
    Basic information The Nissan Rogue liftgate can be opened using a quick forward kicking motion beneath the center area of the rear bumper. The kick motion sensor a is located behind the bumper. When your foot moves under and away from the detection area b while carrying the Intelligent Key, ...

    Front Wheel Hub and Knuckle
    Exploded View Steering knuckle Splash guard Hub bolt Wheel hub and bearing assembly Disc rotor Wheel hub lock nut A. : Comply with the installation procedure when tightening. Refer to Removal and Installation. : N·m (kg-m, ft-lb) : Always replace ...

    For Side and Rollover Collision
    When SRS is activated in a collision FOR SIDE AND ROLLOVER COLLISION: When SRS is activated in a collisionCAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all Nissan Ariya vehicles. WORK PROCEDURE Before performing any of the following steps, e ...