Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Power Supply and Ground Circuit. Lithium Ion Battery 12v
Lithium Ion Battery 12v
Diagnosis Procedure
CHECK FUSE
Check that the following fuse is not blown.
| Signal name | Fuse No. | Capacity |
|---|---|---|
| Battery power supply | 109 | 10A |
Is the inspection result normal?
YES>>GO TO 2.
NO>>Be sure to eliminate cause of malfunction before installing new fuse.
CHECK POWER SUPPLY CIRCUIT
Check voltage between 12V sub battery (lithium ion battery) harness connector and ground.
| 12V sub battery (lithium ion battery) | Signal name | Ignition switch position | Voltage | |
|---|---|---|---|---|
| Connector | Terminal | |||
| B143 | 1 | Battery power supply | OFF | Power supply voltage |
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair harness between fuse and 12V sub battery (lithium ion battery).
CHECK GROUND CIRCUIT
Check continuity between 12V sub battery (lithium ion battery) negative terminal and ground.
| 12V sub battery (lithium ion battery) | Ground | Continuity | |
| Connector | Terminal | ||
| — | Negative terminal | Yes | |
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace 12V sub battery (lithium ion battery) ground circuit.
Other materials:
Dtc/circuit Diagnosis. B2556-73 Push-Btn Ign Sw
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detecting condition
B2556-73
PUSH-BTN IGN SW
(Push-button ignition switch)
Diagnosis condition
—
Signal (terminal)
Push-button ignition switch signal
Threshold
0 - 1. ...
B2720-34 Corner Sensor [rl]
DTC Description
DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2720-34
CORNER SENSOR [RL]
(Corner sensor [rear left])
Diagnosis condition
When ignition switch is ON
Signal (terminal)
Rear sonar sensor signal LH outer
Th ...
Additional Service When Replacing Front Camera Unit
Work Procedure
Always perform the front camera unit configuration after replacing the front camera unit.
Always perform the camera aiming after removing and installing or replacing the front camera unit.
CAUTION:
The system does not operate normally unless the front
camera unit confi ...
