Nissan Rogue (T33) 2021-Present Service Manual: P064d Ecm

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P064d Ecm

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detecting condition
P064D 00

Internal control module

(Internal Control Module O2 Sensor Processor Performance Bank 1) 		Diagnosis condition -
Signal (terminal) A/F sensor 1 (bank 1) signal
Threshold ECM communication error　
Diagnosis delay time 1 sec

POSSIBLE CAUSE

ECM

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

YES>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

Start the engine.

Is DTC P064D detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REPLACE ECM

Replace ECM. Refer to ECM : Removal & Installation.

YES>>

INSPECTION END

    P064a Fuel Pump Control Module
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P064A 00 Fuel pump control module A (Fuel Pump Control Module "A...
    P06b0 Sensor Power Supply 1
    DTC Description DESCRIPTIONECM supplies a voltage of 5 V to some of the sensors systematically divided into 3 groups, respectively. Accordingly, when a short circuit develops in...

    Other materials:

    Fonctionnement du système
    Capteurs sonar centraux Capteurs sonar d’angle Capteurs sonar latéraux (si le véhicule en est équipé) Le système informe le conducteur par des alertes visuelles et sonores de la présence : D’obstacles situés à l’avant lorsque le levier de vitesses est en position D (c ...

    Power Supply and Ground Circuit
    Side Radar Front Lh Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 9 (10 A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit. NO>> GO TO 2. CHECK POWER SU ...

    U0402 Can Communication
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0402 00 Invalid data (TCM) (Invalid Data Received From TCM) Diagnosis condition Ignition switch ON Signal (terminal) — Threshold When ECM is ...