Nissan Rogue (T33) 2021-Present Service Manual: P05da Crankcase Ventilation Valve

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P05da Crankcase Ventilation Valve

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P05DA 00

PCV Regulator Valve Control Circuit High

(PCV Regulator Valve Control Circuit High) 		Diagnosis condition

  • Ignition switch ON

  • ECM send crankcase ventilation valve operation signal
Signal (terminal) -
Threshold ECM internal voltage error
Diagnosis delay time 5 seconds

POSSIBLE CAUSE

  • Harness or connectors

    (Crankcase ventilation valve circuit is open or shorted.)

  • Crankcase ventilation valve

  • ECM

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and warm it up to normal operating temperature.

  2. Let it idle at least 15 seconds under the following condition.

    • A/C switch: OFF

    • Selector lever: N

  3. Drive and accelerate the Nissan Ariya vehicle for 10 seconds under the following condition.

    • Engine speed: 1,800 - 1,900 rpm

    CAUTION:

    Always drive Nissan Ariya vehicle at a safe speed.

  4. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK CRANKCASE VENTILATION VALVE CIRCUIT

Check crankcase ventilation valve circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace error-detected parts.

PERFORM DTC CONFIRMATION PROCEDURE

Perform DTC Confirmation Procedure. Refer to DTC Description.

Is DTC detected again?

YES>>

Replace ECM. Refer to ECM : Removal & Installation.

NO>>

INSPECTION END

    P05d9 Crankcase Ventilation Valve
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P05D9 00 PCV Regulator Valve Control Circuit Low (PCV Regulator ...
    P05ec Cold Start Control
    DTC Description ECM controls fuel injection timing and fuel injection quantity when engine is started with the engine cold.This control promotes the activation of three way cata...

    Other materials:

    Power Supply and Ground Circuit
    Ecm Diagnosis Procedure CHECK THE BATTERY CABLE Turn ignition switch OFF. Check the battery cable for tightening enough. NOTE: Check the continuity between the battery cable and the battery terminal. Is the inspection result normal? YES>> GO TO 2 ...

    B2231-16 Battery Voltage
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2231-16 Battery voltage (Battery voltage) Diagnosis condition When ignition switch is ON. Signal (terminal) Battery power supply Threshold 8 V or le ...

    Dtc/circuit Diagnosis. B0028-09 Side A/b Module Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0028-09 SIDE A/B MODULE RH (Right Side Airbag Deployment Control) Diagnosis condition When ignition switch is ON. Signal (terminal) Front side air bag modu ...