Nissan Rogue (T33) 2021-Present Service Manual: P0486 Egr Differential Pressure Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P0486 00

EGR SENSOR B

(EGR sensor B circuit)
Diagnosis condition —
Signal (terminal) —
Threshold ECM detects that a voltage signal from EGR differential pressure sensor is less than 0.5 V for 5 consecutive seconds.
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors (EGR differential pressure sensor circuit is open or shorted.)

  • EGR differential pressure sensor

FAIL-SAFE

Fail safe mode Nissan Ariya Vehicle behavior
Device fix mode
  • This mode fixes the electric IVT control actuator and the EVT control solenoid valve in the reference position.

  • A control signals is not transmitted to the EGR volume control valve and the EGR volume control is deactivated.

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC P0486 is displayed with the following DTC, perform the trouble diagnosis for the applicable DTC.

  • P06B0

  • P06B3

If applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC P06B0: Refer to DTC Description.

  • DTC P06B3: Refer to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is 10 V or more at ignition switch ON.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and let it idle for 5 seconds.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK EGR DIFFERENTIAL PRESSURE SENSOR POWER SUPPLY

  1. Turn ignition switch OFF.

  2. Disconnect EGR differential pressure sensor harness connector.

  3. Turn ignition switch ON.

  4. Check the voltage between EGR differential pressure sensor harness connector and ground.

    + −

    Voltage

    (Approx.)
    EGR differential pressure sensor
    Connector Terminal
    F89 3 Ground 5 V

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Perform the trouble diagnosis for power supply circuit.

CHECK EGR DIFFERENTIAL PRESSURE SENSOR GROUND CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connector.

  3. Check the continuity between EGR differential pressure sensor harness connector and ECM harness connector.

    + − Continuity
    EGR differential pressure sensor ECM
    Connector Terminal Connector Terminal
    F89 1 F71 106 Existed
  4. Also check harness for short to power.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK EGR DIFFERENTIAL PRESSURE SENSOR INPUT SIGNAL CIRCUIT

  1. Check the continuity between EGR differential pressure sensor harness connector and ECM harness connector.

    + − Continuity
    EGR differential pressure sensor ECM
    Connector Terminal Connector Terminal
    F89 2 F71 93 Existed
  2. Also check harness for short to ground and to power.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace error-detected parts.

CHECK EGR DIFFERENTIAL PRESSURE SENSOR

Check the EGR differential pressure sensor. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Replace EGR differential pressure sensor. Refer to Exploded View.

    P046e Egr Differential Pressure Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P046E 00 EGR SENSOR B (EGR sensor B circuit range/performance) D...
    P04db Crankcase Ventilation System
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P04DB 00 Crankcase Ventilation System Hose Disconnection (Crankc...

    Other materials:

    Led Headlamp. Removal and Installation
    Headlamp Exploded View REMOVAL Radiator core support Headlamp Front combination lamp Front fender assembly Protector tape (USA production models)     : Always replace after every disassembly. : N·m (kg-m, in-lb) DISASSEMBLYFront turn signal la ...

    Diagnosis System (tcm)
    Diagnosis Description 1 Trip Detection Diagnosis and 2 Trip Detection Diagnosis NOTE: “Start the engine and turn OFF the ignition switch after warm-up.� This is defined as 1 trip. 1 TRIP DETECTION DIAGNOSISWhen initial malfunction is detected, TCM memorizes DTC. In these diagnoses, some ...

    For Side and Rollover Collision
    When SRS is activated in a collision FOR SIDE AND ROLLOVER COLLISION: When SRS is activated in a collisionCAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all Nissan Ariya vehicles. WORK PROCEDURE Before performing any of the following steps, e ...