Nissan Rogue (T33) 2021-Present Service Manual: P026b Injection Timing

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P026b Injection Timing

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P026B 00 Injection timing Diagnosis condition —
Signal —
Threshold ECM does not control fuel injection timing properly when engine is running (except engine cold start).
Diagnosis delay time 1 second

POSSIBLE CAUSE

ECM

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

Start engine and drive the Nissan Ariya vehicle as per the similar conditions to Freeze Frame Data for 5 seconds. Hold the accelerator pedal as steady as possible.

CAUTION:

Always drive Nissan Ariya vehicle in safe manner according to traffic conditions and obey all traffic laws when driving.

  • COOLANT TEMP

  • ENGINE SPEED

  • CAL/LD VALUE

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REPLACE ECM

  1. Replace ECM. Refer to ECM : Removal & Installation.

  2. Refer to Work Procedure.

>>

INSPECTION END

    P0261 Fuel Injector (cylinder 1)
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0261 00 CYL1 INJECTOR (Cylinder 1 Injector A Circuit Low) Diagn...
    P02cc Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P02CC 00 CYL1 INJECTOR OFFSET LEARNING (Cylinder 1 Fuel Injector...

    Other materials:

    How to Use This Manual. Tightening Torque of Standard Bolts
    Description This vehicle has both new standard based on ISO* and previous standard bolts/nuts. There are some differences between these two types of bolts/ nuts; shape of the head, grade of strength, hexagonal width across flats and the standard tightening torque. For guidance in discrimin ...

    Basic Inspection. Anti-Pinch Inspection
    Description If any of the following operations are performed, the initialization is necessary for normal operation of anti-pinch function. Refer to Work Procedure. When front power window motor (driver side) replaced. Power supply to the front power window motor (driver side) is not cut ...

    U2259 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2259 87 CAN comm err (steering control unit) [CAN comm err (steering control unit)] Diagnosis condition Ignition switch ON Signal (terminal) CAN commu ...