Nissan Rogue (T33) 2021-Present Service Manual: Heated Oxygen Sensor 2 Heater

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Heated Oxygen Sensor 2 Heater

Component Inspection

CHECK HEATED OXYGEN SENSOR 2 HEATER

  1. Turn ignition switch OFF.

  2. Disconnect heated oxygen sensor 2 (HO2S2) harness connector.

  3. Check resistance between HO2S2 terminals as per the following.

    Heated oxygen sensor 2 Resistance
    Terminal
    1 2 5.4 - 7.3 Ω [at 25°C (77°F)]
    4 1

    ∞Ω

    (Continuity should not exist)
    2
    3
    3 4
    1
    2

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 2.

REPLACE HEATED OXYGEN SENSOR 2

Replace heated oxygen sensor 2. Refer to Exploded View.

CAUTION:

  • Discard any sensor which has been dropped from a height of more than 0.5 m (19.7 in) onto a hard surface such as a concrete floor; use a new one.

  • Before installing new sensor, clean exhaust system threads using Oxygen Sensor Thread Cleaner [commercial service tool (NI-43897-18 or NI-43897-12)] and approved Anti-seize Lubricant (commercial service tool).

>>

INSPECTION END

    Heated Oxygen Sensor 2
    Component Function Check PERFORM COMPONENT FUNCTION CHECK-1 Without CONSULT Start engine and warm it up to normal operating temperature. Turn ignition switch OFF and wait at lea...
    High Pressure Fuel Pump
    Component Function Check CHECK HIGH PRESSURE FUEL PUMP FUNCTION With CONSULT Start engine. Select “FUEL PRES SEN V” in “DATA MONITOR” mode of “ENGINE” using CONSULT ...

    Other materials:

    Dtc/circuit Diagnosis. B2010-1c Battery Voltage
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2010-1C Battery voltage (Battery voltage) Diagnosis condition All times Signal (terminal) Intelligent Key unit battery power supply signal Threshold ...

    Removal and Installation. Steering Gear and Linkage
    Exploded View 1. Outer socket 2. Boot clamp (small diameter) 3. Boot 4. Boot clamp (large diameter) 5. Hole cover seal A. Outer socket lock nut. B. Inner socket lock nut. — — — — CAUTION: Never apply the grease to the surface be ...

    Stationnement/stationnement en pente
    AVERTISSEMENT Ne garez jamais le véhicule sur des matières inflammables telles que de l’herbe sèche, des papiers ou des chiffons, qui pourraient s’enflammer. Ne laissez jamais le moteur tourner lorsque le véhicule est sans surveillance. Ne laissez jamais des enfants ou des anim ...