Nissan Rogue (T33) 2021-Present Service Manual: P0091 Fuel Rail Pressure Control System

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P0091 00

Fuel pressure regulator 1

(Fuel Pressure Regulator "A" Control Circuit Low)
Diagnosis condition Engine running at idle
Signal PUMP signal
Threshold ECM detects High pressure fuel pump circuit is GND short
Diagnosis delay time 5 seconds

POSSIBLE CAUSE

  • Harness or connectors (The high pressure fuel pump circuit is shorted.)

  • High pressure fuel pump

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited.

When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more.

YES>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 10 seconds.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

GO to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK HIGH PRESSURE FUEL PUMP CIRCUIT

  1. Turn ignition switch ON.

  2. Disconnect ECM harness connector and high pressure fuel pump harness connector.

  3. Check the continuity between ECM harness connector and high pressure fuel pump harness connector.

    ECM High pressure fuel pump Continuity
    Connector Terminal Connector Terminal
    F72 7 F82 1 Existed
    2 2
  4. Also check harness for short to power and short to ground.

Is inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace the error-detected parts.

CHECK HIGH PRESSURE FUEL PUMP

Check high pressure fuel pump. Refer to Component Inspection.

Is inspection result normal?

YES>>

INSPECTION END

NO>>

Replace error-detected parts.

    P0090 Frp System
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0090 00 FUEL PUMP (Fuel Pressure Regulator "A" Control Circuit/...
    P0092 Fuel Rail Pressure Control System
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0092 00 Fuel pressure regulator 1 (Fuel Pressure Regulator "A" ...

    Other materials:

    Front Wheel Hub and Knuckle
    Exploded View Steering knuckle Splash guard Hub bolt Wheel hub and bearing assembly Disc rotor Wheel hub lock nut : Comply with the installation procedure when tightening. Refer to Removal and Installation. : N·m (kg-m, ft-lb) : Always replace aft ...

    P02ee Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P02EE 00 Cylinder 1 injector (Cylinder 1 Injector Circuit Range/Performance) Diagnosis condition Injector compensation control is operating Signal — ...

    Dtc/circuit Diagnosis. B0028-09 Side A/b Module Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0028-09 SIDE A/B MODULE RH (Right Side Airbag Deployment Control) Diagnosis condition When ignition switch is ON. Signal (terminal) Front side air bag modu ...