Nissan Rogue (T33) 2021-Present Service Manual: Oil Level Sensor Signal Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Meter, Warning Lamp & Indicator / Type B :: Dtc/circuit Diagnosis / Oil Level Sensor Signal Circuit

DiagnosisProcedure

CHECK OIL LEVEL SENSOR CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect combination meter harness connector and oil level sensor harness connector.

  3. Check continuity between combination meter harness connector and oil level sensor harness connector.

    Combination meter Oil level sensor Continuity
    Connector Terminal Connector Terminal
    M76 37 F63 1 Yes

  4. Check continuity between combination meter harness connector and ground.

    Combination meter Ground Continuity
    Connector Terminal
    M76 37 No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair harness or connector.

CHECK OIL LEVEL SENSOR GROUND CIRCUIT

  1. Check continuity between oil level sensor harness connector and combination meter harness connector.

    Oil level sensor Combination meter Continuity
    Connector Terminal Connector Terminal
    F63 2 M76 38 Yes

  2. Check continuity between oil level sensor harness connector and ground.

    Oil level sensor Ground Continuity
    Connector Terminal
    F63 2 No

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair harness or connector.

CHECK OIL LEVEL SENSOR

Check oil level sensor. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Replace combination meter Refer to Removal and Installation.

NO>>

Replace oil level sensor. Refer to Exploded View.

Component Inspection

CHECK OIL LEVEL SENSOR

  1. Remove the oil level sensor. Refer to Exploded View.

  2. Check the resistance of oil level sensor.

    Terminals

    Resistance (Ω)

    (Approx.)
    Oil level sensor
    1 2 3 –20

Is inspection result normal?

YES>>

Inspection End.

NO>>

Replace oil level sensor unit. Refer to Exploded View.

    Ambient Sensor Signal Circuit
    Diagnosis Procedure CHECK AMBIENT SENSOR POWER SUPPLY Ignition switch OFF. Disconnect ambient sensor harness connector. Ignition switch ON. Check voltage between ambient sensor ...
    Type B. Symptom Diagnosis
    Warning/indicator Lamp Remains on Work Flow The Fuel Gauge Indicator Does Not Operate Description Fuel gauge will not indicate from a certain position. Diagnosis Procedure CONDU...

    Other materials:

    System Description. Component Parts. Electrical Units Location
    Electrical Units Location Component Parts Location No.Component 1. 12V Sub Battery (Lithium Ion Battery) 2. Fusible Link Box (Battery) 3. Battery 4. Relay Box 5. IPDM E/R (Intelligent Power Distribution Module Engine Room) 6. Fusible Link Box (12V Sub B ...

    U0073-00 Control Module Comm Bus a Off
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0073 00 Control module comm Bus A Off (Control module communication Bus A Off) 1 Diagnosis condition When ignition switch is ON. When the power sup ...

    C1070-01 Side G Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1070 01 Side G sensor (Side G sensor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. Signal (termi ...