Nissan Rogue (T33) 2021-Present Service Manual: Multi-Way Control Valve

Component Inspection

CHECK MULTI-WAY CONTROL VALVE-1

With CONSULT

  1. Turn ignition switch ON and engine stopped.

  2. On the CONSULT screen, select “ENGINE�>>“WORK SUPPORT�>>“Engine coolant bypass valve A�.

  3. Check that indication of “Engine coolant bypass valve position�.

Is “141°� or more displayed on CONSULT screen?

YES>>

GO TO 2.

NO>>

Replace multi-way control valve. Refer to Removal and Installation.

CHECK MULTI-WAY CONTROL VALVE-2

With CONSULT

  1. Start the engine.

  2. Warm engine up to the normal operating temperature.

  3. Check the following condition.

    Coolant temperature 10 - 100°C (50 - 212°F)
    Engine oil temperature 120°C (248°F) or less
    A/C switch OFF
  4. Turn ignition switch OFF and wait at least 10 seconds.

  5. Start the engine.

  6. Check “Engine coolant bypass valve position� approximately 2 seconds after engine start.

Is “40°� or less displayed on CONSULT screen?

YES>>

INSPECTION END

NO>>

Replace multi-way control valve. Refer to Removal and Installation.

    Mass Air Flow Sensor
    Component Inspection CHECK MASS AIR FLOW (MAF) SENSOR-1 With CONSULT Turn ignition switch OFF. Reconnect all harness connectors disconnected. Start the engine and warm it up to ...
    On Board Refueling Vapor Recovery (orvr)
    Component Function Check CHECK ORVR FUNCTION Check whether the following symptoms are present. Fuel odor from EVAP canister is strong. Cannot refuel/Fuel odor from the fuel fill...

    Other materials:

    Comb Sw
    CONSULT Function (BCM - COMB SW) DATA MONITORNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item [Unit] Description Rear wiper ON [On/Off] ...

    Can Gateway. Basic Inspection. Additional Service When Replacing 8ch Can Gateway
    Additional Service When Replacing 8ch Can Gateway Work Procedure DescriptionWhen replacing the 8CH gateway, perform "Procedure before replacing" and "Procedure after replacing"CAUTION: Never reuse the parts which has been dropped Dispose 8CH CAN gateway which is paired with Intelligent K ...

    Aluminum Repair
    Sheet Metal Work (aluminum) Sheet Metal Work (Aluminum) Repairing aluminum alloy panels is basically the same as repairing steel panels. Special considerations for repairing aluminum alloy are listed below. Sanding Aluminum alloy panels are softer than steel plates. It is important to se ...