Nissan Rogue (T33) 2021-Present Service Manual: Main Line Between Pwbd and Lib 12v Circuit
Diagnosis Procedure
CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
-
Turn the ignition switch OFF.
-
Disconnect the battery cable from the negative terminal.
-
Disconnect the following harness connectors.
-
BCM
-
Automatic back door control unit
-
12V sub battery (lithium ion battery)
-
-
Check the continuity between the automatic back door control unit harness connector and the 12V sub battery (lithium ion battery) harness connector.
Automatic back door control unit harness connector 12V sub battery (lithium ion battery) harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. B55 32 B143 3 Existed 16 2 Existed
Is the inspection result normal?
YES (Present error)>>Check CAN system type decision again.
YES (Past error)>>Error was detected in the main line between the automatic back door control unit and the 12V sub battery (lithium ion battery).
NO>>Repair the main line between the automatic back door control unit and the 12V sub battery (lithium ion battery).
Other materials:
Telematics System. System Description
Component Parts
With 8" Color Display
Component Parts Location
No. Component Function
1.
Telematics switch
Refer to Telematics Switch.
2.
Microphone
Refer to Microphone.
3.
Air bag diagnosis sensor unit
Provides TCU with the car crash information signal via C ...
Symptom Diagnosis. Engine Can Not Start
Description
Engine does not start when push-button ignition switch is pressed.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry)
Door lock operation (request switch of front/rear/back door) or
trunk/back door open operation (opener switch of ...
P2271 Ho2s2
DTC Description
The heated oxygen sensor 2 has a much longer switching time between
rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage
capacity of the three way catalyst (manifold) causes the longer
switching time.
: 0.71 V
To judge the malfunctions of heated oxyge ...
