Nissan Rogue Owners Manual: Lights

Nissan Rogue Owners Manual / Maintenance and do-it-yourself / Lights

Headlights

Replacing the halogen headlight bulb (if so equipped)

The headlight is a semi-sealed beam type which uses a replaceable headlight (halogen) bulb. Because the headlight assembly must be removed from the vehicle for bulb replacement, see your NISSAN dealer.

CAUTION

Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer.
Do not leave the headlight assembly open without a bulb installed for a long period of time. Dust, moisture, smoke, etc. entering the headlight body may affect bulb performance. Remove the bulb from the headlight assembly just before a replacement bulb is installed.
Only touch the base when handling the bulb. Never touch the glass envelope.
Touching the glass could significantly affect bulb life and/or headlight performance.
High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.

Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer.

Replacing the LED headlight bulb (if so equipped)

If LED headlight bulb replacement is required, see your NISSAN dealer.

Fog lights (if so equipped)

If replacement is required, see your NISSAN dealer.

CAUTION

High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.
When handling the bulb, do not touch the glass envelope.
Use the same number and wattage as originally installed as shown in the chart.
Do not leave the bulb out of the fog light for a long period of time as dust, moisture and smoke may enter the fog light body and affect the performance of the fog light.

Exterior and interior lights

NISSAN Intelligent Key® (if so equipped)

Replace the battery in the Intelligent Key as follows: Remove the mechanical key from the Intelligent Key. Insert a small screwdriver A into the slit B of the corner and twist it to se ...

Exterior and interior lights

Item Wattage (W) Bulb No. Headlight assembly* High 65 H9 Low 55 H11 Park 5 W5W Turn 28/8 ...

Other materials:

Glove box assembly and housing
Removal and Installation REMOVAL Release instrument side finisher (RH) (1) pawls using a suitable tool and remove. : Pawl NOTE: LH side shown; RH similar. Release the glove box damper (1) from the glove box assembly (2) as shown. Release the glove box assembly pawls ...

Coil spring
Exploded View Upper seat Coil spring Lower seat Rubber washer (LH/RH) Rear suspension arm Front Removal and Installation - FWD REMOVAL Remove the rear wheel and tire using power tool. Remove the bolt and separate the rear wheel sensor from the wheel h ...

Front wiper auto stop signal circuit
Component Function Check 1. CHECK FRONT WIPER (AUTO STOP) SIGNAL Select FR WIPER STOP of BCM (WIPER) data monitor item. Operate the front wiper. Check that FR WIPER STOP changes from ON to OFF according to the wiper position Is the inspection result normal? YES ...