Nissan Rogue Service Manual: Removal and installation
POWER SOCKET
Removal and Installation
FRONT POWER SOCKET
Removal
- Remove cluster lid C. Refer to IP-21, "Removal and Installation".
- Release the pawls on the power socket and remove from the cluster lid C.
Installation
Installation is in the reverse order of removal.
CONSOLE POWER SOCKET
Removal
- Remove center console assembly. Refer to IP-18, "Removal and Installation".
- Release the pawls on the console power socket and remove from the center console.
Installation
Installation is in the reverse order of removal.
REAR CARGO POWER SOCKET
Removal
- Remove luggage side lower finisher RH. Refer to INT-34, "LUGGAGE SIDE LOWER FINISHER : Removal and Installation - With Third Row Seat".
- Release the pawls on the rear cargo power socket and remove from the luggage side lower finisher RH.
Installation
Installation is in the reverse order of removal.
Wiring diagram
POWER SOCKET
Wiring Diagram
...
Service data and specifications (SDS)
Power Socket
...
Other materials:
Flat towing for front wheel drive vehicle
(if so equipped)
Towing your vehicle with all four wheels on the
ground is sometimes called flat towing. This
method is sometimes used when towing a vehicle
behind a recreational vehicle, such as a motor
home.
CAUTION
Failure to follow these guidelines can
result in severe transmission dama ...
P0456 EVAP control system
DTC Description
DTC DETECTION LOGIC
This diagnosis detects leaks in the EVAP line between fuel tank and EVAP
canister purge volume control solenoid
valve, using the negative pressure caused by decrease of fuel temperature in the
fuel tank after turning
ignition switch OFF.
If ECM judges t ...
P0524 engine oil pressure
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0524
ENGINE OIL PRESSURE
(Engine oil pressure too low)
An EOP sensor signal voltage applied to ECM remains lower than the
specified
value c ...
