Description
Component Function Check
1. CHECK OPERATION OF METER BUZZER
Does meter buzzer activate? YES >> Inspection End.
NO >> Refer to WCS-42, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK COMBINATION METER INPUT SIGNAL
Select the "Data Monitor" for the "METER/M&A" and check the "BUZZER" monitor value.

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key system) or BCS- 135, "Removal and Installation" (without Intelligent Key system).
Power supply and ground circuit
Seat belt buckle switch signal circuitPrecaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Brake pedal
Adjustment
BRAKE PEDAL HEIGHT
Remove instrument lower panel LH. Refer to IP-22, "Removal and
Installation".
Disconnect the harness connectors from the stop lamp switch and
brake pedal position switch.
Turn the stop lamp switch and brake pedal position switc ...
Wiper and washer system symptoms
Symptom Table
CAUTION:
Perform the self-diagnosis with CONSULT before performing the diagnosis by
symptom. Perform the
diagnosis by DTC if DTC is detected.
...