Nissan Rogue Service Manual: Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch signal to the combination meter.
Component Function Check
1. CHECK COMBINATION METER INPUT SIGNAL
- Ignition ON.
- Monitor seat belt warning lamp while fastening and unfastening the driver seat belt buckle.
Is the inspection result normal? YES >> Inspection End.
NO >> Refer to WCS-43, "Diagnosis Procedure".
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WCS-29, "Wiring Diagram".
1. CHECK COMBINATION METER INPUT SIGNAL
- Turn ignition switch ON.
- Check voltage between combination meter harness connector M76 terminal 28 and ground.
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 2.
2. CHECK SEAT BELT BUCKLE SWITCH LH CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector M76 and seat belt buckle switch LH harness connector B87.
- Check continuity between combination meter harness connector M76 terminal 28 and seat belt buckle switch LH harness connector B87 terminal 1.
- Check continuity between combination meter harness connector M76 terminal 28 and ground.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness or connector.
3. CHECK SEAT BELT BUCKLE SWITCH LH GROUND CIRCUIT
Check continuity between seat belt buckle switch LH harness connector B87 terminal 2 and ground.
Is the inspection result normal? YES >> Inspection End.
NO >> Repair or replace harness or connector.
Component Inspection
1. CHECK SEAT BELT BUCKLE SWITCH
- Turn ignition switch OFF.
- Disconnect the seat belt buckle switch LH connector.
- Check continuity between the seat belt buckle switch LH terminals 1 and 2.
Is the inspection result normal? YES >> Inspection End.
NO >> Replace the seat belt buckle switch LH. Refer to SB-11, "FRONT SEAT BELT BUCKLE : Removal and Installation".
Meter buzzer circuit
Description
The buzzer for the warning chime system is installed in the combination
meter.
The combination meter sounds the buzzer based on the signals transmitted
from various units.
C ...
Parking brake switch signal circuit
Component Function Check
1.CHECK PARKING BRAKE SWITCH OPERATION
Check that brake warning lamp in combination meter turns ON/OFF when parking
brake is actuated.
Is the inspection result normal?
...
Other materials:
CVT fluid cooler system
Cleaning
Whenever an automatic transaxle is repaired, overhauled, or replaced, the CVT
fluid cooler mounted in the
radiator must be inspected and cleaned.
Metal debris and friction material, if present, can be trapped or be deposited
in the CVT fluid cooler. This
debris can contaminate the ...
How to select piston and bearing
DESCRIPTION
Selection points
Selection parts
Selection items
Selection methods
Between cylinder block to
crankshaft
Main bearing
Main bearing grade (bearing
thickness)
Determined by match of cylinder
block bearing housing
grade (inner diameter of housin ...
Tightening torque of standard
bolts
Description
This vehicle has both new standard based on ISO* and previous standard
bolts/nuts. There are some differences
between these two types of bolts/ nuts; shape of the head, grade of strength,
hexagonal width across
flats and the standard tightening torque.
For guidance in d ...
