Nissan Rogue manuals

Nissan Rogue Service Manual: Parking brake switch signal circuit

Nissan Rogue Service Manual / Driver information & multimedia / Warning Chime System / DTC/circuit diagnosis / Parking brake switch signal circuit

Component Function Check

1.CHECK PARKING BRAKE SWITCH OPERATION

Check that brake warning lamp in combination meter turns ON/OFF when parking brake is actuated.

Is the inspection result normal? YES >> Inspection End.

NO >> Proceed to diagnosis procedure. Refer to WCS-45, "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to WCS-29, "Wiring Diagram".

1.CONNECTOR INSPECTION

  1.  Turn ignition switch OFF.
  2.  Disconnect combination meter and parking brake switch connectors.
  3.  Check connectors and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace as necessary.

2.CHECK PARKING BRAKE SWITCH

Check parking brake switch. Refer to WCS-46, "Component Inspection".

Is the inspection result normal? YES >> GO TO 3.

NO >> Replace parking brake switch. Refer to PB-7, "Exploded View".

3.CHECK PARKING BRAKE SWITCH SIGNAL

With CONSULT.

  1.  Connect combination meter connector and parking brake switch connectors.
  2.  Turn ignition switch ON.
  3.  In DATA MONITOR select "PKB SW" and check parking brake switch signal.

Check parking brake switch signal

Is the inspection result normal? YES >> Refer to WCS-37, "Work Flow".

NO >> GO TO 4.

4.CHECK PARKING BRAKE SWITCH CIRCUIT

  1.  Turn ignition switch OFF.
  2.  Disconnect combination meter and parking brake switch connectors.
  3.  Check continuity between combination meter connector M76 terminal 26 and parking brake switch connector E52 terminal 1.

Check parking brake switch circuit

  1. Check continuity between combination meter connector and ground.

Check parking brake switch circuit

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

NO >> Repair or replace malfunctioning components.

Component Inspection

1.CHECK PARKING BRAKE SWITCH

  1.  Turn ignition switch OFF.
  2.  Disconnect parking brake switch connector.
  3.  Check continuity between parking brake switch terminal 1 and ground.

Check parking brake switch

Is the inspection result normal? YES >> Inspection End.

NO >> Replace parking brake switch. Refer to PB-7, "Exploded View".

Seat belt buckle switch signal circuit
Description Transmits a seat belt buckle switch signal to the combination meter. Component Function Check 1. CHECK COMBINATION METER INPUT SIGNAL  Ignition ON.  Monitor seat belt wa ...

Key switch signal circuit (without intelligent key)
Description Transmits a key switch signal to the BCM. Component Function Check 1. CHECK BCM INPUT SIGNAL Select "Data Monitor" for "BCM" and check the "KEY ON SW" mon ...

Other materials:

Difference between predicted and actual distances
Backing up on a steep uphill When backing up the vehicle up a hill, the distance guide lines and the vehicle width guide lines are shown closer than the actual distance. For example, the display shows 3 ft (1.0 m) to the place A , but the actual 3 ft (1.0 m) distance on the hill is the p ...

Front door glass
Exploded View Front door Front regulator Front power window motor Front door glass rear run Front door glass front run Front door glass  Front door glass rubber run Removal and Installation REMOVAL  Remove the front door finisher. Refer to INT-15, "Remov ...

System
System Description SYSTEM DIAGRAM OPERATION DESCRIPTION  When rear window defogger switch is turned ON while ignition switch is ON, the rear window defogger switch transmits rear window defogger switch signal to BCM.  BCM turns rear window defogger relay ON when rear windo ...

В© 2014-2025 Copyright www.nirogue.com