Nissan Rogue (T33) 2021-Present Service Manual: License Plate Lamp Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Controls :: Exterior Lighting System / Led Headlamp :: Dtc/circuit Diagnosis / License Plate Lamp Circuit

Component Function Check

CHECK TAIL LAMP OPERATION

Check that tail lamp is turned ON when lighting switch is turned 1ST.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Check tail lamp circuit. Refer to Component Function Check.

CHECK LICENSE PLATE LAMP OPERATION

  1. Ignition switch ON.

  2. With operating the lighting switch, check that the license plate lamp is turned ON.

    Lighting switch 1ST : License plate lamp ON
    Lighting switch OFF or AUTO* : License plate lamp OFF

    *: Only when the illumination judgement by intelligent auto light system is OFF.

Is the inspection result normal?

YES>>

License plate lamp circuit is normal.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK LICENSE PLATE LAMP BULB

  1. Ignition switch OFF.

  2. Check license plate lamp bulb.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace corresponding license plate lamp bulb. Refer to Replacement.

CHECK LICENSE PLATE LAMP POWER SUPPLY CIRCUIT

  1. Disconnect IPDM E/R connector and license plate lamp connector.

  2. Check continuity between IPDM E/R harness connector and license plate lamp harness connector.

    IPDM E/R License plate lamp Continuity
    Connector Terminal Connector Terminal
    RH E119 4 D517 1 Yes
    LH D516

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness.

CHECK LICENSE PLATE LAMP GROUND CIRCUIT

Check continuity between license plate lamp harness connector and ground.

License plate lamp — Continuity
Connector Terminal
RH D517 2 Ground Yes
LH D516

Is the inspection result normal?

YES>>

Replace corresponding license plate lamp bulb. Refer to Replacement.

NO>>

Repair or replace harness.

    Tail Lamp Circuit
    Component Function Check CHECK TAIL LAMP OPERATION Ignition switch ON. With operating the lighting switch, check that the tail lamp is turned ON. Lighting switch 1ST : Tail Lamp...
    Stop Lamp Circuit
    Component Function Check CHECK STOP LAMP OPERATION Ignition switch ON. With operating the brake pedal, check that the stop lamp and high-mounted stop lamp is turned ON. Depresse...

    Other materials:

    Active Noise Control Unit
    Reference Value VALUES ON THE DIAGNOSIS TOOL Monitor Item Condition Value/Status Active sound control operating condition Active sound control system is not operating. Off Active sound control system is operating. On Active noise control operating condition Active noise c ...

    Removal and Installation. Rear Seat Belt
    Exploded View 1. Anchor bolt 2. Seat belt pre-tensioner retractor RH 3. Seat belt hook RH 4. Anchor plate RH 5. Retaining washer 6. Anchor plate LH 7. Seat belt hook LH 8. Seat belt pre-tensioner retractor LH 9. Shoulder bracket RH 10. ...

    Main Line Between Hvac and a-Bag Circuit
    Diagnosis Procedure CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harness connectors. A/C amp. Harness connectors M31 and E152 Check the continuity between the ...