Nissan Rogue (T33) 2021-Present Service Manual: Ignition Relay-1

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Power Control System / Power Distribution System :: Dtc/circuit Diagnosis / Ignition Relay-1

Diagnosis Procedure

CHECK IGNITION RELAY-1 POWER SUPPLY

  1. Disconnect ignition relay-1 connector.

  2. Check voltage between ignition relay-1 harness connector and ground.

    (+) (–)

    Voltage

    (Approx.)
    Ignition relay-1
    Connector Terminal
    J-3 2 Ground Battery voltage
    3

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness or connectors.

CHECK IGNITION RELAY-1

Check ignition relay-1. Refer to Component Inspection.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Replace ignition relay-1.

CHECK IGNITION RELAY-1 CONTROL SIGNAL CIRCUIT

  1. Disconnect BCM connector.

  2. Check continuity between BCM harness connector and ignition relay-1 harness connector.

    With type A meter
    BCM Ignition relay-1 Continuity
    Connector Terminal Connector Terminal
    E60 122 J-3 1 Yes
    With type B meter
    BCM Ignition relay-1 Continuity
    Connector Terminal Connector Terminal
    E29 105 J-3 1 Yes

  3. Check continuity between BCM harness connector and ground.

    With type A meter
    BCM — Continuity
    Connector Terminal
    E60 122 Ground No
    With type A meter
    BCM — Continuity
    Connector Terminal
    E29 105 Ground No

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.

Component Inspection

CHECK IGNITION RELAY-1

  1. Ignition switch OFF.

  2. Disconnect ignition relay-1 connector.

  3. Check continuity between ignition relay-1 terminals.

Ignition relay-1 Condition Continuity
Terminals
12 V direct current supply between terminals and . Yes
No current supply No

Is the inspection result normal?

YES>>

Inspection End

NO>>

Replace ignition relay-1.

    Accessory Relay
    Diagnosis Procedure CHECK ACCESSORY RELAY POWER SUPPLY Disconnect accessory relay connector. Check voltage between accessory relay harness connector and ground. (+) (–) Voltag...
    Ignition Relay-2
    Diagnosis Procedure CHECK IGNITION RELAY-2 POWER SUPPLY Disconnect ignition relay-2 connector. Check voltage between ignition relay-2 harness connector and ground. (+) (–) Vol...

    Other materials:

    U1cab-02 Intake Door Motor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1CAB-02 Intake door motor (Intake door motor) Diagnosis condition Ignition switch ON Signal (Terminal) LIN (door motor) signal Threshold A/C amp. i ...

    Dtc/circuit Diagnosis. B0010-11 Assist A/b Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0010-11 ASSIST A/B MODULE (Passenger Frontal Stage 1 Deployment Control) Diagnosis condition When ignition switch is ON. Signal (terminal) Passenger air ba ...

    P0264 Fuel Injector (cylinder 2)
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0264 00 CYL2 INJECTOR (Cylinder 2 Injector "A" Circuit Low) Diagnosis condition — Signal (terminal) — Threshold Direct injector driver uni ...