Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U2152-87 Can Comm Err (adas Control Unit 2)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: U2152-87 Can Comm Err (adas Control Unit 2)

DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
U2152-87

CAN comm err (ADAS control unit)

[CAN communication error (ADAS control unit)] 		Diagnosis condition Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold BCM cannot communicate CAN communication signal.
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Dtc/circuit Diagnosis. U2152-57 Can Comm Err (adas Control Unit)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U2152-57 CAN comm err (ADAS control unit) [Control area netw...
    Dtc/circuit Diagnosis. U2154-87 Can Comm Err (miu)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...

    Other materials:

    Turbocharger Boost Sensor
    Component Inspection CHECK TURBOCHARGER BOOST SENSOR Turn ignition switch OFF. Remove turbocharger boost sensor with its harness connector. Install pressure pump (A) to turbocharger boost sensor (1). CAUTION: When insert a pressure pump hose to the sensor, be careful to the damag ...

    Mirrors
    Inside mirror Basic information Adjust the angle of the inside mirror to the desired position for a clear rearward view in your Nissan Rogue. Manual anti-glare type (if so equipped) The night position 1 will reduce glare from the headlights of vehicles behind you at night. Use the day positio ...

    Calibration of Decel G Sensor
    Description CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed. Refer to Work Procedure. ×: Required —: Not required Procedure Decel G sensor calibration Removing/ installing ABS actuator and electric unit (control unit) × ...