Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U2118-87 Can Comm Err (intelligent Key)

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Dtc/circuit Diagnosis :: U2118-87 Can Comm Err (intelligent Key)

DTC Description

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
U2118-87

CAN comm err (Intelligent Key)

[Controller area network communication error (Intelligent Key)] 		Diagnosis condition When ignition switch is ON
Signal (terminal) CAN communication signal
Threshold When driver seat control unit cannot communicate CAN communication signal
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Check “Self diagnosis result” mode of “DRIVER SEAT”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Perform trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Dtc/circuit Diagnosis. B2921-A3 Driver Seat Control Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2921-A3 Driver seat control unit (Driver seat control unit)...
    Dtc/circuit Diagnosis. Reclining Motor
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Reclining motor” in “Active test” mode of “DRIVER SEAT”. Check reclining motor LH operati...

    Other materials:

    Rear Door Alert
    The Rear Door Alert system helps remind the driver to check the rear seat(s) before leaving the Nissan Rogue. Under certain conditions, the system indicates that an object or passenger may still be in the rear seat. The Rear Door Alert system is initially disabled. The driver can enable the system ...

    B2601-42 Memory Failure for Firmware Over the Air
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition B2601-42 Memory failure for firmware over the air Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold Errors are detected in the memory for software auto ...

    Adas Control Unit. Basic Inspection
    Additional Service When Replacing Adas Control Unit 2 Without Propilot Assist 2.1 Work Procedure Always perform the additional service after replacing the ADAS control unit 2.ADAS CONTROL UNIT 2 CONFIGURATION Perform saving Nissan Ariya vehicle internal information according to "Replace ECU" i ...