Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U1ca3-08 Lin Communication 4
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1CA3-08 |
LIN communication 4 (Local interconnect network communication 4) |
Diagnosis condition | Engine running |
| Signal (terminal) | LIN (heated seat) signal (terminal #45) | ||
| Threshold | A/C amp. is not transmitting or receiving LIN communication with each seat heater | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
-
Fuse
-
Harness or connectors (seat heater circuit is open or short to ground)
-
Each seat cushion heater
-
A/C amp.
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Start the engine.
-
Select “Self diagnosis result” mode of “HVAC”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
CHECK DTC
CONSULT
-
Start the engine.
-
Select “Self diagnosis result” mode of “HVAC”.
-
Check following DTC.
DTC Items
(CONSULT screen terms)Reference U1CA6-02 FRONT SEAT HEATER RH COMMUNICATION DTC Description U1CA7-02 FRONT SEAT HEATER LH COMMUNICATION DTC Description U1CA8-02 REAR SEAT HEATER RH COMMUNICATION DTC Description U1CA9-02 REAR SEAT HEATER LH COMMUNICATION DTC Description
Is DTC detected?
YES>>Perform DTC diagnosis procedure that is detecting.
NO>>Replace A/C amp. Refer to Removal and Installation.
Other materials:
With Idle Start/stop. Symptom Diagnosis. Charging System
Charging System
Symptom Table
Symptom Reference
Discharged 12V battery
Refer to Work Flow (With EXP-800 NI or GR8-1200 NI) or Work Flow (Without EXP-800 NI or GR8-1200 NI).
The charge warning lamp does not illuminate when the ignition switch is set to ON.
The charge warning lamp ...
Dtc/circuit Diagnosis. Power Supply and Ground Circuit
Moonroof Motor Assembly
Diagnosis Procedure
CHECK FUSE
Ignition switch OFF.
Check that the following fuse is not blown (open):
Fuse No. Capacity
31
15 A
Is the fuse blown (open)?
YES>>
Repair the blown (open) fuse after repairing the affected circuit if a fuse ...
Fuel Pressure Check
Work Procedure
FUEL PRESSURE RELEASEFUEL PRESSURE RELEASE
With CONSULT
Turn ignition switch ON.
Perform “ENGINE” in “WORK SUPPORT” mode with CONSULT.
Start the engine.
After engine stalls, crank it two or three times to release all fuel pressure.
Turn ignition swit ...
