Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2490-19 Front Seat Heater Lh

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Seat / Dtc/circuit Diagnosis :: B2490-19 Front Seat Heater Lh

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
B2490-19

FRONT SEAT HEATER LH

(Front seat heater LH) 		Diagnosis condition Engine running
Signal (terminal) —
Threshold CPU in front seat heater LH detect heating wire resistance less than 1.3 Ω
Diagnosis delay time 1.5 seconds or more

POSSIBLE CAUSE

  • Seat cushion heater LH

  • Front seat back heater LH

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Select “Self diagnosis result” mode of “HVAC”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK FRONT SEAT BACK HEATER LH CIRCUIT (SHORT TO GROUND)

  1. Ignition switch OFF.

  2. Disconnect front seat heater LH connector and front seat back heater LH connector.

  3. Check continuity between front seat back heater LH harness connector and ground.

    Front seat back heater LH ー Continuity
    Connector Terminal
    B209 2 Ground No

Is the inspection result normal?

YES>>

Replace front seat back heater LH. Refer to Disassembly and Assembly.

NO>>

Replace seat cushion heater LH. Refer to Disassembly and Assembly.

    Dtc/circuit Diagnosis. B2490-13 Front Seat Heater Lh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2490-13 FRONT SEAT HEATER LH (Front seat heater LH) Diagnos...
    Dtc/circuit Diagnosis. U1ca3-08 Lin Communication 4
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition U1CA3-08 LIN communication 4 (Local interconnect network com...

    Other materials:

    Side Radar Front Lh
    Reference Value VALUES ON THE DIAGNOSIS TOOL Monitor item Condition Value/Status Horizontal alignment value When the ignition switch ON and the side radar adjustment is completed Displays the horizontal alignment value TERMINAL LAYOUTPHYSICAL VALUES Terminal No. (Wire color) Descr ...

    Power Supply and Ground Circuit
    Around View Monitor Control Unit Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown (open). Power source Fuse No. Capacity ACC power supply 40 10 A 1131 10 A1 1: With ProPILOT Assist 2.1 Is the fuse blown (open)? YES>> Be sure to elimina ...

    B20de-72 Ign Relay Off Circ
    DTC Description IPDM E/R operates the ignition relay when it receives an ignition ON signal from BCM via CAN communication. Turn the ignition relay OFF by pressing the push-button ignition switch once when the Nissan Ariya vehicle speed is 2.5 MPH (4 km/h) or less. Turn the igniti ...