Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Personal Lamp Control Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Controls :: Interior Lighting System / Dtc/circuit Diagnosis :: Personal Lamp Control Circuit

Component Function Check

CAUTION:

Before performing the diagnosis, check that the following are normal:

  • Interior room lamp power supply circuit

  • Map lamp control circuit

  • Each interior room lamp bulb

CHECK MAP LAMP OPERATION

  1. Switch the map lamp switch to DOOR.

  2. Check that the map lamp is turned ON when any door opens (except back door).

Is the inspection normal?

YES>>

GO TO 2.

NO>>

Check map lamp control circuit. Refer to Component Function Check .

CHECK PERSONAL LAMP OPERATION

CONSULT

  1. Switch the map lamp switch and personal lamp switch to DOOR.

  2. Open the front door LH.

  3. Ignition switch ON.

  4. Select “Interior lamp” in "Active test" mode of BCM.

  5. With operating the test item, check that the personal lamp turns ON/OFF.

    ON : Personal lamp turns ON
    OFF : Personal lamp turns OFF

Does the personal lamp turns ON/OFF?

YES>>

Personal lamp control circuit is normal.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK PERSONAL LAMP CONTROL CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect map lamp assembly connector and personal lamp connector.

  3. Check continuity between map lamp assembly harness connector and personal lamp harness connector.

    Map lamp assembly Personal lamp Continuity
    Connector Terminal Connector Terminal
    R6 8 RH R28 5 Yes
    LH R27

  4. Check continuity between personal lamp harness connector and ground.

    Personal lamp Terminal Continuity
    Connector
    RH R28 5 No
    LH R27

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harnesses.

CHECK PERSINAL LAMP GROUND CIRCUIT

Check continuity between personal lamp harness connector and ground.

Personal lamp Terminal Continuity
Connector
RH R28 1 Yes
LH R27

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harnesses.

CHECK MAP LAMP CIRCUIT

Check continuity between map lamp assembly terminals.

Map lamp assembly Condition Continuity
Terminal
4 8 Map lamp switch is "DOOR" position Yes
Map lamp switch is "OFF" position No

Is the inspection result normal?

YES>>

Replace corresponding personal lamp bulb. Refer to Replacement.

NO>>

Replace map lamp assembly. Refer to Removal and Installation .

    Dtc/circuit Diagnosis. Room Lamp Control Circuit
    Component Function Check CAUTION: Before performing the diagnosis, check that the following are normal: Interior room lamp power supply circuit Map lamp control circuit Each int...
    Dtc/circuit Diagnosis. Mood Lamp Control Circuit
    Component Function Check CAUTION: Before performing the diagnosis, check that the following are normal: Interior room lamp power supply circuit Mood lamp (center console) bulb (...

    Other materials:

    Chassis control
    Basic information The chassis control system in the Nissan Rogue uses an electric control module that manages the following functions: Intelligent Trace Control Active Ride Control (if so equipped) Intelligent Trace Control This feature analyzes the driver’s steering, acceleration and braking ...

    I-BSI driving situations
    Basic information Indicator on Indicator off Indicator flashing Illustration 1 — Approaching from behind Another vehicle approaching from behind Illustration 1: When another vehicle enters the monitored area from the rear in an adjacent lane, the side indicator light on the Nissan Rogue i ...

    System Description. Diagnosis System (occupant Detection System Control Unit)
    CONSULT Function APPLICATION ITEMCONSULT performs the following functions. Diagnosis mode CGW Status Description Restricted Mode Diag Test Mode Open Mode CGW Information Display Display Display Display the current CGW mode Enables CGW to switch mode Data mo ...