Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Parking Brake Switch

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Parking Brake System / Dtc/circuit Diagnosis :: Parking Brake Switch

Component Inspection

CHECK PARKING BRAKE SWITCH

  1. Disconnect the 12V battery negative terminal.

  2. Disconnect the parking brake switch harness connector.

  3. Check the continuity when parking brake switch is operated.

    Parking brake switch Continuity
    Condition Terminals
    When parking brake switch is neutral 3 5 Yes
    6 7 Yes
    3 6 No
    5 7 No
    When parking brake switch is pulled 3 5 Yes
    5 7 Yes
    3 6 No
    6 7 No
    When parking brake switch is pushed 3 6 Yes
    6 7 Yes
    3 5 No
    5 7 No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace the parking brake switch. Refer to Removal and Installation.

CHECK PARKING BRAKE SWITCH INDICATOR

Apply 12 V between parking brake switch connector terminals, and check the parking brake switch indicator lamp.

CAUTION:

  • Connect fuse between terminals when applying the voltage.

  • Never make the terminals short.

Parking brake switch Condition Parking brake switch indicator
Terminals
(+) (—)
2 9 Apply 12 V between parking brake switch connector terminals (2 and 9). ON

Is the inspection result normal?

YES>>

Inspection End

NO>>

Replace the parking brake switch. Refer to Removal and Installation.

    Basic Inspection. Change of System Mode
    Description Refer to Description.
    Dtc/circuit Diagnosis. Electric Parking Brake Indicator Lamp
    Component Function Check CHECK ELECTRIC PARKING BRAKE WARNING LAMP FUNCTION Check that electric parking brake warning lamp in combination meter turns ON for approximately 1 seco...

    Other materials:

    C10b1-01 Parking Brake Actuator (lh)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C10B1 01 Parking brake actuator (LH) [Parking brake actuator (left)] Diagnosis condition When parking brake is apply or release Signal (terminal) — ...

    Dtc/circuit Diagnosis. B0073-09 Pre-Ten Rear Lh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0073-09 PRE-TEN REAR LH (Second Row Left Seat Belt Pretensioner Deployment Control) Diagnosis condition When ignition switch is ON. Signal (terminal) Rear ...

    Power Supply and Ground Circuit
    Ecm Diagnosis Procedure CHECK THE BATTERY CABLE Turn ignition switch OFF. Check the battery cable for tightening enough. NOTE: Check the continuity between the battery cable and the battery terminal. Is the inspection result normal? YES>> GO TO 2 ...