Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Electric Parking Brake Indicator Lamp

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Parking Brake System / Dtc/circuit Diagnosis :: Electric Parking Brake Indicator Lamp

Component Function Check

CHECK ELECTRIC PARKING BRAKE WARNING LAMP FUNCTION

Check that electric parking brake warning lamp in combination meter turns ON for approximately 1 second after ignition switch is ON.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Refer to Diagnosis Procedure.

CHECK ELECTRIC PARKING BRAKE INDICATOR LAMP FUNCTION

Check that electric parking brake indicator lamp in combination meter turns ON/OFF when parking brake is operated.

NOTE:

Electric parking brake indicator lamp turns ON when parking brake is operated (when parking brake switch is pulled).

Is the inspection result normal?

YES>>

Inspection End

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair / replace harness, connector, terminal, fuse, or fusible link.

PERFORM SELF DIAGNOSIS RESULT

CONSULT

  1. Ignition switch OFF.

    CAUTION:

    Be sure to wait for 10 seconds or more after the ignition switch OFF.

  2. Operate and release the parking brake five times.

  3. Select "Self diagnosis result" mode of "ABS".

Is DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 3.

CHECK COMBINATION METER

Check the combination meter.

  • Type A meter: Refer to On Board Diagnosis Function.

  • Type B meter: Refer to On Board Diagnosis Function.

Is inspection result normal?

YES>>

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

NO>>

Repair / replace the combination meter.

  • Type A meter: Refer to Removal and Installation.

  • Type B meter: Refer to Removal and Installation.

    Dtc/circuit Diagnosis. Parking Brake Switch
    Component Inspection CHECK PARKING BRAKE SWITCH Disconnect the 12V battery negative terminal. Disconnect the parking brake switch harness connector. Check the continuity when pa...
    Symptom Diagnosis. Parking Brake Does Not Release
    Description When the parking brake cannot be released by the parking brake switch.CAUTION: Never reuse the parking brake actuator. When replacing parking brake actuator, replace...

    Other materials:

    P06e6 Internal Control Module
    DTC Description DESCRIPTIONECM supplies a voltage of 5 V to some of the sensors systematically divided into 3 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the s ...

    Type B. Precaution. Precautions
    Precautions Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and ...

    U2212 Can Comm Err (brake Unit)
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition U2212 87 CAN communication error brake unit Diagnosis condition Ignition switch ON Signal (terminal) CAN communication signal Threshold ECM is not recieving CAN communication ...