Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Front Wiper Auto Stop Signal Circuit
Component Function Check
CHECK FRONT WIPER STOP POSITION SIGNAL
CONSULT
-
Select “FR WIPER STOP POSITION� in “Data monitor� mode of “IPDM E/R�.
-
Operate the front wiper.
-
With the front wiper operation, check the monitor status.
Monitor item Condition Monitor status FR WIPER STOP POSITION Front wiper motor Front wiper stop position Stop position Any position other than front wiper stop position Active
Is the inspection result normal?
YES>>Front wiper stop position signal circuit is normal.
NO>>Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK IPDM E/R OUTPUT VOLTAGE
-
Ignition switch OFF.
-
Disconnect front wiper motor connector.
-
Ignition switch ON.
-
Check voltage between front wiper motor harness connector and ground.
(+) (−) Voltage
(Approx.)Front wiper motor Connector Terminal E20 4 Ground Battery voltage
Is the inspection result normal?
YES>>Replace front wiper motor. Refer to Removal and Installation.
NO>>GO TO 2.
CHECK FRONT WIPER MOTOR (AUTO STOP) CIRCUIT
-
Ignition switch OFF.
-
Disconnect IPDM E/R connector.
-
Check continuity between IPDM E/R harness connector and front wiper motor harness connector.
IPDM E/R Front wiper motor Continuity Connector Terminal Connector Terminal E120 33 E20 4 Yes -
Check continuity between IPDM E/R harness connector and ground.
IPDM E/R (—) Continuity Connector Terminal E120 33 Ground No
Is the inspection result normal?
YES>>Replace IPDM E/R. Refer to Removal and Installation.
NO>>Repair or replace harness.
Other materials:
Signal Buffer
CONSULT Function (BCM - SIGNAL BUFFER)
DATA MONITORNOTE:
The following table includes information (items)
inapplicable to this Nissan Ariya vehicle. For information (items)
applicable to this vehicle, refer to CONSULT display items.
Monitor item
[Unit] Description
Brake switch 1
[On/ ...
Settings
Basic information
The settings menu in the Nissan Rogue allows the user to adjust what appears on the vehicle information display and customize various onboard functions:
VDC Setting
Driver Assistance
Head-Up Display (if so equipped)
ECO Mode Setting
TPMS Setting
Clock
Vehicle Settings
Main ...
Service After Replacing or Removing Engine Parts
Description
X: Applicable Part name Service performed Required service Reference
Replacement Removal
ECM
X
—
Additional service when replacing ECM
Work Procedure
Fuel injector offset learning
Work Procedure
Turbocharger wastegate control solenoid valve d ...
