Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: C1731-16 Tire Pressure Sensor Fl
DTC Description
NOTE:
The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
-
Activate and display TPMS sensor IDs
-
Display tire pressure reported by the TPMS sensor
-
Read TPMS DTCs
-
Register TPMS sensor IDs
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| C1731-16 |
Tire pressure sensor FL (Tire pressure sensor front left) |
Diagnosis condition | Drive at a speed of 25 MPH (40 km/h) or more reaches 10 minutes in total. | |
| Signal (terminal) | Tire pressure sensor signal. | |||
| Threshold | Front left tire pressure sensor battery voltage is low. | |||
| Diagnosis delay time | 2 second or more. | |||
POSSIBLE CAUSE
Front left tire pressure sensor
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION
CONSULT
-
Drive the Nissan Ariya vehicle at 25 MPH (40 km/h) or more reaches 10 minutes in total.
NOTE:
Avoid driving in areas with radio interference.
-
Stop the Nissan Ariya vehicle.
-
Select “Self diagnosis result” mode of “BCM”.
Is DTC “C1731-16” detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident .
NO>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
NOTE:
The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
-
Activate and display TPMS sensor IDs
-
Display tire pressure reported by the TPMS sensor
-
Read TPMS DTCs
-
Register TPMS sensor IDs
PERFORM SELF DIAGNOSIS RESULT
Replace front left tire pressure sensor even if other DTCs are displayed along with “C1731-16” in “Self diagnosis result” mode of “BCM”.
>>
Replace front left tire pressure sensor. Refer to Removal & Installation.
Other materials:
Parameter Writing
Work Procedure
DescriptionWhen replace each camera, it is necessary to write the camera parameters using CONSULT.Write to around view monitor control unit according to "Parameter writing" procedure of "CONSULT Operation Manual".Work ProcedurePARAMETER WRITING
CONSULT
Power switch ON.
Sel ...
System
System Description
Chassis control to integrally control the driving system was adopted.
Chassis control module inputs the necessary information for control
from CAN communication and each switch and integrally controls each
system. Refer to the following table for systems controlled a ...
Guide de dépistage des pannes courantes
Informations de base
Plusieurs systèmes d’aide à la conduite du Nissan Rogue utilisent des composants communs, tels que la caméra avant ou les capteurs radar, afin d’assurer leur fonctionnement coordonné. Lorsqu’un message contextuel d’avertissement s’affiche sur l’écran d’inform ...
