Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: C1700-54 Control Unit

Nissan Rogue (T33) 2021-Present Service Manual / Suspension :: Road Wheels & Tires / Dtc/circuit Diagnosis :: C1700-54 Control Unit

DTC Description

NOTE:

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
C1700-54

Control unit

(Control unit) 		Diagnosis condition When Ignition switch is ON.
Signal (terminal) —
Threshold Tire pressure monitoring system configuration has not been performed.
Diagnosis delay time 1 second or less.

POSSIBLE CAUSE

Configuration is not completed.

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM SELF DIAGNOSIS RESULT

CONSULT

Select “Self diagnosis result” mode of “BCM”.

Is DTC “C1700-54” detected?

YES>>

Refer to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

NOTE:

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

BCM CONFIGURATION

Perform configuration of BCM. Refer to Description.

>>

GO TO 2.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to Description.

Does low tire pressure warning lamp turn OFF?

YES>>

Inspection End.

NO>>

Replace BCM. Refer to Removal and Installation.

    Basic Inspection. Tire Pressure Sensor Id Registration
    Description This procedure must be performed. After replacement of a tire pressure sensor or BCM. After replacement of tire or road wheel. NOTE: ID registration is unnecessary i...
    Dtc/circuit Diagnosis. C1700-86 Control Unit
    DTC Description NOTE: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information....

    Other materials:

    Removal and Installation. Sunshade Motor Assembly
    Exploded View Refer to Exploded View. Removal and Installation REMOVALCAUTION: Before removing sunshade motor, check that sunshade is fully opened. After removing sunshade motor, never attempt to rotate sunshade motor assembly as a single unit. Remove headlining to make work space. ...

    Symptom Diagnosis. Front Passenger Side Power Window Does Not Operate
    When Both Power Window Main Switch and Front Power Window Switch (passenger Side) Are Operated Diagnosis Procedure CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) POWER SUPPLY AND GROUND CIRCUIT Check front power window switch (passenger side) power supply and ground circuit. Refer to Diagnosis ...

    Engine Cover
    Exploded View Engine cover Stud Bracket Bracket         : N·m (kg-m, in-lb) Removal and Installation REMOVALRemove the engine cover by pulling it off in an upwards direction.CAUTION: Never damage or scratch engine cover when installing or ...